IEEE 1361-2014 PDF

IEEE 1361-2014 PDF

IEEE Guide for Selecting, Charging, Testing, and Evaluating Lead-Acid Batteries Used in Stand-Alone Photovoltaic (PV) Systems

$60.50 $121.00 -50%
isbn 9780738191720
Product Code: IEEE 1361
Stock In Stock
Published: 06/16/2014
Number of Pages: 39
File Size: 1 file, 800 KB

Available Options

Product Description

IEEE Guide for Selecting, Charging, Testing, and Evaluating Lead-Acid Batteries Used in Stand-Alone Photovoltaic (PV) Systems

Introduction: This introduction is not part of IEEE Std 1361™-2014, IEEE Guide for Selecting, Charging, Testing, and Evaluating Lead-Acid Batteries Used in Stand-Alone Photovoltaic (PV) Systems. The PV system designer depends on the capacity of a storage battery for reliable extended operation of the system load during hours of darkness and below average solar resource. Photovoltaic systems can subject batteries to harsh operational environments with minimal control of recharge profiles. The economics of photovoltaic modules limit the ability to charge the battery at more traditional motive power deep-cycle charge rates and times. Typical charge rates for small stand-alone PV systems are less than 6.5 amperes (A) and may be less than 2.0 A per 100 Ah of battery capacity. Relatively low rates, coupled with the unpredictability of the solar resource, result in limited recharge capabilities. Stand-alone PV systems are typically utilized in remote locations with minimal power resources, which limits the amount of initial battery boost charging possible. In daily operation, the limited available PV charging source combined with relatively low charge regulation voltages may be insufficient to provide a full charge to the battery. In an effort to identify appropriate stand-alone PV system parameters together with appropriate battery technology, a repeatable test procedure is provided to verify PV system parameters based on laboratory battery performance testing. This test procedure is designed to

Contents:

  • 1.1 Scope
  • 1.2 Purpose
  • 4.1 Arc hazard
  • 4.2 Hydrogen venting
  • 4.3 Spill containment
  • 5.1 Battery characteristics
  • 5.2 Selection criteria
  • 5.3 PV system parameters
  • 6.1 Objectives
  • 6.2 Parameter selection
  • 6.3 PV battery test procedure
  • 6.4 Evaluation of test results

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEEE 1361-2014 PDF

IEEE 1361-2014 PDF

$60.50 $121.00