IEEE Standard for Universal Power Adapter for Mobile Devices
Introduction: This introduction is not part of IEEE Std 1823™-2015, IEEE Standard for Universal Power Adapter for Mobile Devices. This standard focuses on a generic power adapter designed for reuse across brands, models, and years. A compliant adapter will supply a nominal 21 V at up to 130 W and may negotiate voltages up to 60 V at power levels up to, but less than, 240 W. Each power adapter will have one or more power ports to service load devices with control of each port via a serial communications link, an electrical variant of the CAN bus standard. Input power may be ac or dc depending on the market being served. A group of laptop, notebook, and other computing device, entertainment, and gaming system manufacturers approached the Microprocessor Standards Committee to define a common connector configuration, a power specification, and a communications protocol for a reusable durable power adapter system. This standard is the result of the foresight of that group. IEEE Std 1823-2015 defines a power delivery and communication connection between a power adapter and a power-using device greater than 10 W up to, but less than, 240 W range. The communications are used to coordinate the power delivery and provide identification between the power adapter and the power-using device. While primarily intended for portable computing and entertainment devices, this standard applies to adapters serving other mobile devices in use around the office, home, or vehicle. To enable the powering of a wide
Contents:
- 1.1 Scope
- 1.2 Purpose
- 1.3 Goals for the standard
- 1.4 Basic operation
- 1.5 Priorities
- 1.6 Connector and cables
- 1.7 Conformance levels
- 3.1 Definitions
- 3.2 Acronyms and abbreviations
- 4.1 Communications
- 4.2 UPAMD ports
- 4.3 CAN 2.0B 29b ID frame
- 4.4 Interconnect configuration
- 5.1 Device detection
- 5.2 CANx and CANy data communication pair
- 5.3 Typical source connection
- 5.4 Typical Smart Sink connection
- 5.5 Typical 20 W mute power connection
- 5.6 Typical low power, less than 20 W connection
- 5.7 Communications power for smart devices
- 7.1 Fault messages—Socket 00b
- 7.2 Protocol messages—Socket 01b
- 7.3 Power messages—Socket 06
- 7.4 Identity messages—Socket 07
- 7.5 Public Key (optional)
- 8.1 Data logical channel header
- 8.2 Route_ID management
- 8.3 Local routing tables
- 8.4 Addressing
- 8.5 Broadcast addressing