IEEE Guide for Selection and Installation of Electrical Cables and Cable Systems in Hazardous (Classified) Locations on Oil and Gas Land Drilling Rigs
Introduction: This introduction is not part of IEEE Std 2740-2020, IEEE Guide for Selection and Installation of Electrical Cables and Cable Systems in Hazardous (Classified) Locations on Oil and Gas Land Drilling Rigs. The oil and gas industry depends on working within regulatory requirements, industry standards, and industry guidelines. In the case of oil and gas well land drilling rigs in the United States, there are no standards or governing codes that directly address cables and cable systems. Land drilling rig applications often combine hazardous (classified) locations, extreme ambient temperature ranges, vibration, temporary installations, flexibility, and ability to transport over various terrains. The National Electrical Code® (NEC®) NFPA 70 standard does not cover the selection, performance requirements, and procedures for flexible electrical cables and cable systems installed in hazardous (classified) locations on oil and gas land drilling rigs. Instead, its focus is on fixed installations in hazardous (classified) locations. When users have tried to apply National Electrical Code regulations for fixed hazardous (classified) locations, they have encountered conflicts between portability, flexibility, and solutions permitted for fixed hazardous (classified) locations; therefore, users have relied on the API RP 14F and API RP 14FZ recommended practices for installation methods that are not specific to oil and gas land drilling rigs since they reference offshore facilities. This gap
Contents:
- 1.1 Scope
- 1.2 Purpose
- 1.3 Word usage
- 3.1 Definitions
- 3.2 Acronyms and abbreviations
- 5.1 Overview
- 5.2 General
- 5.3 Ampacity
- 5.4 Voltage
- 5.5 Ambient temperature
- 5.6 Duty factors
- 5.7 Termination
- 6.1 General
- 6.2 Power and lighting systems
- 6.3 Instrumentation, control, and communication systems wiring
- 6.4 Armor grounding
- 6.5 Motor cables for variable frequency drive (VFD) applications
- 6.6 Extra-hard usage flexible cord
- 6.7 Medium voltage cable (2001 V to 15 kV)
- 7.1 Cable systems
- 7.2 Color coding and identification of cables
- 7.3 Cable retention
- 7.4 Cable-bending radius
- 7.5 DC conductor insulation
- 9.1 Overview
- 9.2 Class I, Division 1
- 9.3 Class I, Division 2
- 10.1 Overview
- 10.2 Class I, Zone 1
- 10.3 Class I, Zone 2