IEEE Guide for Identification, Testing, and Evaluation of the Dynamic Performance of Excitation Control Systems
Introduction: This introduction is not part of IEEE Std 421.2-2014, IEEE Recommended Practice for Overvoltage and Insulation Coordination of Transmission Systems at 1000 kV AC and Above. This guide presents dynamic performance criteria, definitions, and test objectives for excitation control systems as applied by electric utilities. It should be specifically noted that the term excitation control system refers to the entire control system including the synchronous machine and power system as well as the excitation system. The Working Group on Excitation Control System Dynamic Performance of the Excitation Systems and Controls Subcommittee of the Energy Development and Power Generation Committee adopted many definitions and performance criteria, which are common to all control systems, and derived others specifically related to excitation control systems. In doing this, the material in IEEE Std 421.1, IEEE Standard Definitions for Excitation Systems for Synchronous Machines and the now discontinued IEEE Std 100-1988, IEEE Standard Dictionary of Electrical and Electronics Terms (ANSI) was heavily used. Efforts were made not to conflict with existing definitions and criteria, but to clarify, supplement, and more fully define them as related specifically to excitation control systems. Definitions from these standards, which are reproduced in this standard, are included in Clause 3. In preparing this guide, the working group recognized that both factory testing and field testing of excitation c
Contents:
- 4.1 Overall
- 4.2 Large signal performance
- 4.3 Small signal performance
- 4.4 Effects of excitation limiters
- 5.1 General
- 5.2 Ceiling current
- 5.3 Ceiling voltage
- 5.4 Excitation system voltage response time
- 5.5 High initial response (HIR)
- 5.6 Excitation system nominal response
- 5.7 Large signal dynamic response
- 6.1 General
- 6.2 Small signal dynamic response
- 6.3 Frequency response characteristic (linear system)
- 6.4 Complex frequency domain (s plane)
- 6.5 Small signal performance indices
- 7.1 Types of synchronous machine oscillations
- 7.2 Application of power system stabilizers
- 8.1 General
- 8.2 Factory testing
- 8.3 Field testing
- 8.4 Fault testing
- 8.5 Power system disturbances
- 9.1 General
- 9.2 Excitation control system components
- 9.3 Field testing
- 9.4 Field testing with power system stabilizers
- 9.5 Special considerations for digital systems
- 9.6 Testing reactive load sharing and line drop compensation
- 9.7 Testing power factor and var controllers