IEEE Standard for Relays and Relay Systems Associated with Electric Power Apparatus
Introduction: This revision of IEEE Std C37.90 contains significant changes in content and organization so it will harmonize more closely with currently published IEC standards whenever possible. The standard has also been updated to include many changes to provide for a more effective document that is now representative of currently manufactured relay products used in the industry. The changes are as described in the following list. a) Clause 2, Normative references, has been added where required. b) Clause 3, Definitions, has been revised to provide for alphabetical classification by function. c) Clause 4, Service conditions, has been revised to provide categories for specific temperature ranges and differentiation of ambient and extreme temperature ranges. Relative humidity now specifies relay or relay systems. Other conditions have been changed to show numeric designations. d) Clause 5, Electrical ratings, specifies additional standard current and voltage ratings and notes, applicable to Table 3. Table 4 specifies additional maximum design voltages for dc control. Table 7 and Table 8 specify coil resistance/burden at ambient temperature 25 °C. A subclause has been added to address latching current requirements. e) Clause 6, Heating limits of temperature rise for coils, has been revised to add information on how the temperature rise of the coils is to be determined. f) Clause 7, Mechanical requirements, has been added to provide information on the mechanical durability of relays, plug-i
Scope: This standard specifies standard service conditions, standard ratings, performance requirements, and testing requirements for relays and relay systems used to protect and control power apparatus. A relay system may include computer interface equipment and/or communications interface equipment, such as a carrier transmitter/receiver or audio tone equipment. It does not cover relays designed primarily for industrial control, for switching communication or other low-level signals, or any other equipment not intended for control of power apparatus. 1 Information about the documents referenced in this clause can be found in Annex A. Copyright © 2006 IEEE. All rights reserved.
Contents:
- 1.1 Scope
- 1.2 Purpose
- 4.1 Usual service conditions
- 4.2 Unusual service conditions
- 5.1 Standard current and voltage ratings for relays
- 5.2 Maximum design voltage and current for relays
- 5.3 Allowable variations from rated voltage for voltage operated auxiliary relays
- 5.4 Allowable variation from rated voltage and current for protective relays
- 5.5 Allowable ac component in dc control voltage supply
- 5.6 Short time thermal withstand
- 5.7 Make, carry, and interrupt ratings for tripping output circuits
- 5.8 Make, carry, and interrupt ratings for output circuits not rated for tripping
- 5.9 Published data for auxiliary relays
- 7.1 Mechanical durability of relay operation
- 7.2 Mechanical durability of plug-in relays
- 7.3 Mechanical durability of relay setting controls
- 7.4 Shock and vibration
- 8.1 General requirements
- 8.2 Dielectric power frequency tests
- 8.3 Impulse voltage tests