Quality Assurance Requirements for Measuring Equipment - Part 1: Metrological Confirmation System for Measuring Equipment
Introduction: . . . . . . . . . . . . ..*.......~...............~................................... A.2 Initial choice of confirmation intervals D.OOODO....D...D*.O~.*~~~..*....~ A.3 Methods of reviewing confirmation inten/als ..,,......,...,...,..a Bibliography ~.....,....................,,........,,................,..,..,..,.......,.,. . . .
Scope: 1.1 This part of ISO 10012 contains quality assur- ante requirements for a Supplier to ensure that measurements are made with the intended accuracy. lt also contains guidance on the implementation of the requirements. 1.2 This patt of ISO 10012 specifies the main fea- tures of the confirmation System to be used for a Supplier’s measuring equipment. 1.3 This part of ISO 10012 is applicable to measur- ing equipment used in the demonstration of com- pliance with a specification: it does not apply to other items of measuring equipment. This part of ISO 10012 does not deal extensively with other el- ements that may affect measurement results such as methods of measurement, competence of Personne1 etc.; these are dealt with more specifically in other International Standards, such as those referred to in 14 . . 1.4 This part of ISO 10012 is applicable: to testing laboratories, including those providing a calibration Service; this includes laboratories oper- ating a quality System in accordance with lSO/IEC Guide 25; to Suppliers of products or Services who operate a quality System in which measurement results are used to demonstrate compliance with specified requirements; this includes operating Systems that meet the requirements of ISO 9001, ISO 9002 and ISO 9003. The guidance given in ISO 9004 is also relevant; to other organizations where measurement is used to demonstrate compliance with specified requirements. 1.5 The role of the Purchaser in monitoring a Sup- plier’s compliance with the requirements of this part of ISO 10012 may be fulfilled by a third Party, such as an accreditation or certification body. Normative references The following Standards contain provisions which, through reference in this text, constitute provisions of this part of ISO 10012. At the time of publication, the editions indicated were valid. All Standards are subject to revision, and Parties to agreements based on this part of ISO 10012 are encouraged to investi- gate the possibility of applying the most recent edi- tions of the Standards indicated below. Members of IEC and ISO maintain registers of currently valid International Standards. ISO 8402:1986, Quality - Vocabulary. ISO 9001 :1