ISO 10074-2021 PDF

ISO 10074-2021 PDF

Anodizing of aluminium and its alloys-Specification for hard anodic oxidation coatings on aluminium and its alloys

$71.50 $143.00 -50%
Product Code: ISO 10074
Stock In Stock
Edition: 4TH
Published: 05/2021
Number of Pages: 26
File Size: 1 file, 1 Byte

Available Options

Product Description

Anodizing of aluminium and its alloys — Specification for hard anodic oxidation coatings on aluminium and its alloys

Introduction: Hard anodizing is an electrolytic treatment which results in the formation of a hard and usually thick coating of alumina used primarily for engineering purposes. Hard anodizing can be applied to cast or wrought aluminium and aluminium alloys; however, alloys containing more than 5 % copper and/or 8 % silicon and die casting alloys require special anodizing procedures. To obtain optimum microhardness, wear resistance or low surface roughness characteristics, low contents of alloy are selected. Unless otherwise specified, articles are anodized after all heat-treatment, machining, welding, forming and perforating operations. The best results are achieved on machined surfaces. Sharp edges are machined to a radius of at least 10 times the intended thickness to avoid “burning” and/or spalling. Hard anodizing will usually result in a dimensional increase on each surface equal to about 50 % of the coating thickness. The dimensions of the component prior to anodizing will allow for this, if necessary. The thickness is generally within the range of 25 μm to 150 μm. Low thickness (up to 25 μm) is sometimes used in a variety of applications, such as splines and threads. Normal thickness (50 μm to 80 μm) is used for wear or insulation requirements. High thickness (150 μm) is used for repairing purposes, but thick coatings tend to be softer in outer regions. Very hard coatings reduce the fatigue strength. This phenomenon can be minimized by applying shot peening before hard anodizing (see

Scope: This document specifies requirements for hard anodic oxidation coatings on aluminium and its alloys, including test methods. It also specifies the information to be supplied by the customer to the anodizer (see Annex A). It is not applicable to coatings produced by processes such as those referred to as plasma electrolytic oxidation, micro-arc oxidation, plasma-chemical anodic oxidation, anodic spark deposition or spark anodizing.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 10074-2021 PDF

ISO 10074-2021 PDF

$71.50 $143.00