ISO 10094-2-2021 PDF

ISO 10094-2-2021 PDF

Pneumatic fluid power-Electropneumatic pressure control valves-Part 2: Test methods to determine main characteristics to include in the supplier's literature

$60.00 $120.00 -50%
Product Code: ISO 10094-2
Stock In Stock
Edition: 2ND
Published: 11/2021
Number of Pages: 38
File Size: 1 file, 2 Bytes

Available Options

Product Description

Transmissions pneumatiques - Appareils électropneumatiques de distribution à commande continue de pression - Partie 2: Méthodes d'essai pour déterminer les principales caractéristiques à inclure dans la documentation des fournisseurs

Introduction: In pneumatic fluid power systems, power is transmitted and controlled through a gas under pressure within a circuit. When pressure tracking or pressure regulation is required, electro-pneumatic continuous pressure control valves can be used to track a variable set point with low tracking error or to maintain the pressure of the gas at an approximately constant level. These control valves continuously modulate the pneumatic pressure of a system in response to a continuous electrical input signal and link the electrical input value to a proportional pressure value. It is therefore necessary to know some performance characteristics of these electro-pneumatic continuous pressure control valves in order to determine their suitability. ISO 10094-2:2021(E)  © ISO 2021 – All rights reserved

Scope: This document specifies the test procedures and a method of presenting results concerning the parameters which define the main characteristics to be included in the supplier's literature of the electro-pneumatic continuous pressure control valves, conforming to ISO 10094-1. The purpose of this document is: — to facilitate comparison by standardizing the test methods and the presentation of the test results, and — to assist in the proper application of these components in compressed air systems. The specified tests are intended to allow comparison between the different types of continuous pressure control valves; these are not production tests to be carried out on each manufactured product. The tests described in this document are for components with an exhaust port vented to the atmosphere. NOTE 1 The tests related to non-electrically modulated pneumatic continuous pressure control valves are specified in ISO 6953-2. NOTE 2 The tests related to electro-pneumatic continuous flow control valves are specified in ISO 10041-2. NOTE 3 ISO 6953-3 provides an alternate dynamic test method for flow-rate characteristics using an isothermal tank instead of a flow meter. However, this method measures only the decreasing flow rate part of the hysteresis curve of the forward flow and relief flow characteristics.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 10094-2-2021 PDF

ISO 10094-2-2021 PDF

$60.00 $120.00