ISO 10300-2-2023 PDF

ISO 10300-2-2023 PDF

Calculation of load capacity of bevel gears-Part 2: Calculation of surface durability (macropitting)

$113.50 $227.00 -50%
Product Code: ISO 10300-2
Stock In Stock
Edition: 3.
Published: 08/2023
Number of Pages: 42
File Size: 1 file, 2 Bytes

Available Options

Product Description

Calculation of load capacity of bevel gears — Part 2: Calculation of surface durability (macropitting)

Introduction: When ISO 10300:2001 (all parts) became due for its first revision, the opportunity was taken to include hypoid gears, since previously the series only allowed for calculating the load capacity of bevel gears without offset axes. The former structure is retained, i.e. three parts of the ISO 10300 series, together with ISO 6336-5, and it is intended to establish general principles and procedures for rating of bevel gears. Moreover, ISO 10300 (all parts) is designed to facilitate the application of future knowledge and developments, as well as the exchange of information gained from experience. In view of the decision for ISO 10300 (all parts) to cover hypoid gears also, a separate clause: “Gear flank rating formulae — Method B2” has been included in this document, while the former method B was renamed method B1. It became necessary to present a new, clearer structure of the three parts, which is illustrated in ISO 10300-1:2023, Figure 1. NOTE ISO 10300 (all parts) gives no preferences in terms of when to use method B1 and when to use method B2. This document deals with the failure of gear teeth by macropitting, a fatigue phenomenon. Two varieties of macropitting are recognized, initial and destructive macropitting. In applications employing low hardness steel or through hardened steel, initial macropitting frequently occurs during early use and is not deemed serious. Initial macropitting is characterized by small pits which do not extend over the entire facewidth or profile dep

Scope: This document specifies the basic formulae for use in the determination of the surface load capacity of straight and helical (skew), Zerol and spiral bevel gears including hypoid gears, and comprises all the influences on surface durability for which quantitative assessments can be made. This document is applicable to oil lubricated bevel gears, as long as sufficient lubricant is present in the mesh at all times. The formulae in this document are based on virtual cylindrical gears and restricted to bevel gears whose virtual cylindrical gears have transverse contact ratios of εvα < 2. The results are valid within the range of the applied factors as specified in ISO 10300-1. The formulae in this document are not directly applicable to the assessment of other types of gear tooth surface damage, such as plastic yielding, scratching, scuffing or any other type not specified. NOTE This document is not applicable to bevel gears which have an inadequate contact pattern under load. The user is cautioned that when the formulae are used for large average mean spiral angles (βm1 + βm2)/2 > 45°, for effective pressure angles αe > 30° and/or for large facewidths b > 13 mmn, the calculated results of this document should be confirmed by experience.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 10300-2-2023 PDF

ISO 10300-2-2023 PDF

$113.50 $227.00