Mechanical vibration — Laboratory method for evaluating vehicle seat vibration — Part 3: Specification of dynamic dummies for Z-axis motion
Introduction: Vehicle seats play an important role in reducing the vibration transmitted to occupants. While conventional seats are widely used in transport vehicles such as cars, buses, trains, and airplanes, suspension seats are commonly adopted to cope with severe vibration environments in earth-moving machinery, agricultural wheeled tractors, and industrial trucks. It is often required that the dynamic performance of vehicle seats be tested in the laboratory. The International Organization for Standardization and the European Committee for Standardization have published several standards defining laboratory methods for evaluating the dynamic performance of different types of vehicle seats. Such standards include ISO 7096[4] for earth-moving machinery, ISO 5007[1] for agricultural wheeled tractors, and EN 13490[5] for industrial trucks. They require that the seat effective amplitude transmissibility (SEAT) factor, an important dynamic performance index of vehicle seats, be obtained experimentally using both a light and a heavy participant, see Annex D. As has been recognized in the practical use of the mentioned standards, finding suitable participants for vibration tests of vehicle seats is frequently neither easy nor convenient. The use of participants also raises safety and ethics concerns. These issues have motivated the design and development of dynamic dummies that can replace participants for vibration tests of vehicle seats. Regardless of its shape and structure, a dynamic dummy
Scope: This document specifies dynamic dummies used as replacements for participants in vibration tests of vehicle seats in laboratory. This document is applicable to seats installed in earth-moving machinery, agricultural wheeled tractors, and industrial trucks. This document specifies technical requirements, acceptance criteria, and a validation test for dynamic dummies representing the human body in two mass groups: lightweight (52 kg to 55 kg) and heavyweight (98 kg to 115 kg). It only applies to passive and active dynamic dummies used for vibration tests of vehicle seats in the Z-axis (vertical) direction. This document defines, for the two mass groups, the biodynamic response characteristics that the dynamic dummies are required to reproduce to represent those of the participants to be replaced. This document gives guidance on conducting future research to explore the degree of convergence that can be reached when the dynamic performance of seats is measured with participants and with dynamic dummies conforming to this document. NOTE 1 For seat testing, results have shown that the benefit of using a dynamic dummy is highly dependent on the excitation and dynamic characteristics of the seats. Depending on the type of vibration excitation applied, studies have suggested that the use of dynamic dummies can show benefit over an inert mass of equivalent weight only when testing suspension seats with higher natural frequency (>2 Hz). NOTE 2 The use of dynamic dummies has been reported to tend to overestimate the vibration isolation performance of seats compared with that measured with participants. Several factors can be in cause and require further investigation, one of them being the influence of the legs possibly not being adequately considered when using dynamic dummies.