Oil and gas industries including lower carbon energy — Cements and materials for well cementing — Part 5: Determination of shrinkage and expansion of well cement formulations
Introduction: When Portland cement reacts with water, there is an overall reduction in the absolute volume of components: Vc + Vw > Vch (1) where is the volume of cement; Vw is the volume of water; Vch is the volume of cement hydrates. In this document the absolute volume decrease [(Vc + Vw) − Vch] is referred to as hydration shrinkage, although in other documents it can also be referred to as chemical shrinkage, total chemical contraction, or hydration volume reduction. Depending on the exposure conditions, presence of external stresses during setting and, most importantly, access to external water, the hydration shrinkage may lead to bulk shrinkage of the set cement. The change in the sample dimensions is referred to as bulk shrinkage or expansion. Bulk shrinkage and expansion of the cement refer to the result of the measurement of a linear dimensional change or volume change. The volume to which all volume changes are related is the volume of the slurry immediately after mixing and emplacement in the experimental equipment. For small values of shrinkage or expansion, typically the case in well cement systems, the fractional volume dimensional change can be approximated as 3 times the fractional linear dimensional change. Bulk shrinkage may cause: — formation of a micro-annulus, potentially affecting cement evaluation logs; — loss of zonal isolation leading to crossflow or sustained casing pressure; — lack of a hydraulic seal when using cement inflatable packers; — poor sealing of abando
Scope: This document provides the methods for the testing of well cement formulations to determine the dimension changes during the curing process (cement hydration) at atmospheric and elevated pressure and the stress generated by expansion in a confined environment under elevated temperature and pressure.