ISO 10494-2018 PDF

ISO 10494-2018 PDF

Turbines and turbine sets - Measurement of emitted airborne noise - Engineering/survey method

$129.00 $258.00 -50%
Product Code: ISO 10494
Stock In Stock
Edition: 2ND
Published: 04/2018
Number of Pages: 46
File Size: 1 file, 1 Byte

Available Options

Product Description

Turbines and turbine sets - Measurement of emitted airborne noise - Engineering/survey method

Introduction: 0.1 Background Control of noise from machines or equipment requires effective exchange of acoustical information among the several parties concerned. These include the manufacturer, specifier, installer and user of the machine or equipment. This acoustical information is obtained from measurements. These measurements are useful only if they are carried out under specified conditions to obtain defined acoustical quantities using standardized instruments. The sound power level data determined according to this document is essentially independent of the environment in which the data are obtained. This is one of the reasons for using sound power level to characterize the sound emitted by various types of machine equipment. Sound power level data are useful for the following: a) calculating the approximate sound pressure level at a given distance from a machine operating in a specified environment; b) comparing the noise radiated by machines of the same type and size; c) comparing the noise radiated by machines of different types and sizes; d) determining whether a machine complies with a specified upper limit of noise emission; e) planning in order to determine the amount of transmission loss or noise control required under certain circumstances; f) engineering work to assist in developing quiet machinery and equipment. This document gives requirements for the measurement of the noise emission of turbines and turbine sets. It has been prepared in accordance with ISO 3740:2000 on

Scope: This document specifies methods for measuring the noise emission of a turbine or turbine set under steady-state operating conditions. It specifies methods for measuring the sound pressure levels on a measurement surface enveloping a source, and for calculating the sound power level produced by the source. It gives requirements for the test environment and instrumentation, as well as techniques for obtaining the surface sound pressure level from which the A-weighted sound power level of the source and octave or one-third-octave band sound power levels are calculated. These methods can be used to conduct performance tests even if the purpose of the test is simply to determine the sound pressure level around the machine. This document is applicable to turbines and turbine sets: — for power plant and industrial applications (e.g. stationary); — for installation on board ships, or offshore installations, road and railway vehicles. It does not apply to gas turbines in aircraft applications. This document is applicable to only the part of the turbine set (turbine, driven equipment and attached components) located above the floor and inside a continuous enveloping measurement surface bounded by this floor. It is applicable to steady-state operation and excludes transients such as start-up and shut-down, when the noise emission can be higher for short times. Under these conditions, this document does not apply.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 10494-2018 PDF

ISO 10494-2018 PDF

$129.00 $258.00