Pressure regulators for use with medical gases - Part 1: Pressure regulators and pressure regulators with flow-metering devices
Introduction: Pressure regulators are used to reduce high cylinder pressure to a lower pressure suitable for use with medical equipment or for delivery of gas directly to a patient. These functions cover a wide range of inlet and outlet pressures and flows which require specific design characteristics. It is important that the operating characteristics of pressure regulators are specified and tested in a defined manner. A pressure regulator normally has coupled to it a device which controls the flow, such as a flow control device or a fixed orifice. The flow can be indicated by a flowmeter or by a flowgauge. It is essential that regular inspection and maintenance be undertaken to ensure that the pressure regulator continues to meet the requirements of this document. This document pays particular attention to — use of suitable materials, — safety (mechanical strength, leakage, safe relief of excess pressure and resistance to ignition), — gas specificity, — cleanliness, — type testing, — marking, and — information supplied by the manufacturer. Annex A contains rationale statements for some of the requirements of this document. The clauses and subclauses marked with an asterisk (*) after their number have corresponding rationale included to provide additional insight into the reasoning that led to the requirements and recommendations that have been incorporated into this document. It is considered that knowledge of the reasons for the requirements will not only facilitate the proper applicati
Scope: This document specifies the design, construction, type testing, and marking requirements for pressure regulators (as defined in 3.18) intended for the administration of medical gases and their mixtures in the treatment, management, diagnostic evaluation and care of patients or for gases used for driving surgical tools. Examples of gases include oxygen, medical air and oxygen/nitrous oxide mixtures. This document applies to pressure regulators: a) intended to be connected to cylinders by the operator; b) with integral flow-metering devices intended to be connected to cylinders by the operator; c) that are an integral part of medical equipment (e.g. anaesthetic workstations, lung ventilators, resuscitators). A pressure regulator can be provided with pressure outlet or flow outlet, and can be adjustable or pre-set. pressure regulators are intended to be fitted to refillable cylinders with a working pressure up to 30 000 kPa ( 300 bar) and can be provided with devices which control and measure the flow of the medical gas delivered.