Statistical methods — Guidelines for the evaluation of conformity with specified requirements
Introduction: Conformity assessment is a systematic examination of the extent to which an entity conforms to a specified criterion. The objective is to provide assurance of conformity, either in the form of a supplier’s declaration, or of a third-party certification (see ISO/IEC Guide 2, 2004). A specification is usually formulated as a single limiting value, LV, or as a set of (upper and lower) limiting values for a measurable characteristic. When the specification refers, e.g. to health-related characteristics, the limiting values are sometimes termed threshold limit value TLV, or permissible exposure limits, PEL. Whenever conformity assessment involves measurement or sampling uncertainty, it is common practice to invoke elements from the theory of statistical hypothesis testing to provide a formal procedure. With the knowledge of the measurement procedure and of its behaviour with regard to the uncertainty of its outcomes, it is possible to estimate and control the risk of making erroneous declarations of conformity or non-conformity to the specifications. An operational way of formulating requirements of assurance is to require that the risk of (erroneously) declaring a non-conforming entity to be conforming should be small. Consequently, it is necessary to tolerate a (large) risk that an entity, which only marginally conforms, will fail to be declared as conforming. Applying a two-stage procedure instead of a one-stage procedure can decrease this risk. When a test for non-conformity i
Scope: This document sets out guidelines for checking conformity with quantifiable characteristics using the test or measurement result and its associated measurement uncertainty. This document is applicable whenever the uncertainty may be quantified according to the principles laid down in ISO/IEC Guide-98-3 (GUM). The term uncertainty is thus a descriptor for all elements of variation in the measurement result, including uncertainty due to sampling. This document does not give rules for how to act when an inconclusive result of a conformity test has been obtained. NOTE There are not limitations on the nature of the entity subject to the requirements nor on the quantifiable characteristic. Examples of entities together with quantifiable characteristics are given in Table A.1.