Nuclear energy — Light water reactors — Decay heat power in non-recycled nuclear fuels
Introduction: The decay heat power of nuclear fuels is the thermal power produced by radioactive decay of fission and activation products of the nuclear fuel. Decay heat is one of the contributors to the total heat emitted from the nuclear fuel during the reactor operation, representing about <7 % of the total heat. As decay heat continues to be released after shutdown of a nuclear reactor, it is an important physical quantity for the design of systems in which the decay heat power should be taken into consideration as a heat source. This document provides an alternative to dedicated and validated calculation codes, as it provides values for the local generation of decay heat power as a function of the thermal fuel power during operation. The values for the fission product component of decay heat are based on fits to measured data for short cooling times less than ~105 s[2], and on measurements and computational simulations for longer times. Values for other components of decay heat are developed to provide conservative estimates. Therefore, at longer cooling times where fission products represent an increasingly smaller relative contribution to total decay heat, this document becomes increasing conservative, and alternative methods such as dedicated computer codes may provide more accurate estimates. The spatial distribution of the energy conversion into heat, e.g. γ-radiation, is not considered. If required, evaluation of this is left to the user. The calculation procedure used has the a
Scope: This document provides the basis for calculating the decay heat power of non-recycled nuclear fuel of light water reactors. For this purpose the following components are considered: — the contribution of the fission products from nuclear fission; — the contribution of the actinides; — the contribution of isotopes resulting from neutron capture in fission products. This document applies to light water reactors (pressurized water and boiling water reactors) loaded with a nuclear fuel mixture consisting of 235U and 238U. Application of the fission product contribution to decay heat developed using this document to other thermal reactor designs, including heavy water reactors, is permissible provided that the other contributions from actinides and neutron capture are determined for the specific reactor type. Its application to recycled nuclear fuel, like mixed-oxide or reprocessed uranium, is not permissible. The calculation procedures apply to decay heat periods from 0 s to 109 s.