ISO 1070-2018 PDF

ISO 1070-2018 PDF

Hydrometry - Slope-area method

$113.50 $227.00 -50%
Product Code: ISO 1070
Stock In Stock
Edition: 3RD
Published: 11/2018
Number of Pages: 34
File Size: 1 file, 1 Byte

Available Options

Product Description

Hydrometry - Slope-area method

Introduction: The slope–area method is an indirect method of determining discharge in open channels when direct measurement of the flow is not possible because of the timing of the flow or because the site is too hazardous for direct measurement techniques. The method is usually used to document the discharge of a flood and to extend the stage–discharge rating of a stream flow gauging station above direct measurements of discharge. The method can also be used at locations where bridge, cableway or boat measurements are not possible. Water discharge is computed using flow resistance formulae based on channel characteristics, water-surface profiles, and a roughness or friction coefficient. vi © ISO 2018 – All rights reserved

Scope: This document specifies a method of determining discharge in open channels from observations of the surface slope and cross-sectional area of the channel. It is applicable to use under special conditions when direct measurement of discharge by typically more accurate methods, such as the velocity-area method, is not possible. Generally, the method can be used to determine discharge a) for a peak flow that left high-water marks along the stream banks, b) for a peak flow that left marks on a series of water-level gauges or where peak stages were recorded by that series of gauges, and c) for flow observed at the time of determining gauge heights from a series of gauges. The method is commonly used to undertake the extension of stage–discharge relationships above the highest gauged flows. It does not apply to determining discharges in tidal reaches.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 1070-2018 PDF

ISO 1070-2018 PDF

$113.50 $227.00