ISO 10896-2-2016 PDF

ISO 10896-2-2016 PDF

Rough-terrain trucks - Safety requirements and verification - Part 2: Slewing trucks

$129.00 $258.00 -50%
Product Code: ISO 10896-2
Stock In Stock
Edition: 1.
Published: 02/15/2016
Number of Pages: 56
File Size: 1 file, 830 Bytes

Available Options

Product Description

Rough-terrain trucks - Safety requirements and verification - Part 2: Slewing trucks

Introduction: Variable-reach trucks are known by a variety of terms, including “telehandlers” and “multi-purpose handlers”. The rough-terrain variable-reach trucks covered by this part of ISO 10896 are designed to transport loads to and place them on elevated work areas and can be driven on unimproved or disturbed terrain. They can also be equipped with a variety of attachments (e.g. mowers, sweepers). © ISO 2016 – All rights reserved

Scope: This part of ISO 10896 specifies general safety requirements for slewing rough-terrain variable-reach trucks (hereafter known as “trucks”), consisting of a lower chassis with a slewing upper structure equipped with a telescopic lifting means (pivoted boom), on which a load handling device (e.g., carriage and fork arms) is typically fitted. Fork arms and other integrated attachments are considered to be parts of the truck. Other standards, in addition to the relevant provisions of this part of ISO 10896, can apply to the attachments. This part of ISO 10896 is not applicable to the following: a) rough terrain variable-reach trucks covered by ISO 10896-1 (non-slewing); b) industrial variable-reach trucks covered by ISO 3691-2; c) mobile cranes; d) machines designed primarily for earth-moving, such as loaders, even if their buckets are replaced by fork arms (see ISO 20474); e) trucks designed primarily with variable-length load suspension elements (e.g. chain, ropes) from which the load may swing freely in all directions; NOTE Additional requirements for trucks intended for freely swinging load applications, their lifting devices and attachments, and personnel/work platform applications on trucks, are being developed by ISO/TC 110/SC4. f) trucks designed primarily for container handling. The significant hazards covered by this part of ISO 10896 are listed in Annex A. This part of ISO 10896 does not address hazards that can occur — during manufacture, — when handling suspended loads, which may swing freely, — when lifting personnel, — when using trucks on public roads, — when operating in potentially explosive atmospheres, or — with a battery, LPG or hybrid as the primary power source. INTERNATIONAL STANDARD ISO 10896-2:2016(E) © ISO 2016 – All rights reserved ISO 10896-2:2016(E) 2 Normative references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 2328, Fork-lift trucks — Hook-on type fork arms and fork arm carriages —

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 10896-2-2016 PDF

ISO 10896-2-2016 PDF

$129.00 $258.00