ISO 11040-7-2024 PDF

ISO 11040-7-2024 PDF

Prefilled syringes-Part 7: Packaging systems for sterilized subassembled syringes ready for filling

$60.00 $120.00 -50%
Product Code: ISO 11040-7
Stock In Stock
Edition: 2.
Published: 06/2024
Number of Pages: 32
File Size: 1 file, 1 Byte

Available Options

Product Description

Seringues préremplies - Partie 7: Systèmes d’emballage pour les seringues stérilisées prêtes à l’emploi préremplissables

Introduction: At the start of prefilled syringe processing by the pharmaceutical industry, syringes made of tubing glass were delivered to the pharmaceutical companies in the form of a so called non-sterile “bulkware” only. The process steps such as washing, drying, inner lubrication, sealing the syringe with a closure system, sterilization, as well as filling, and closing were then performed by the pharmaceutical companies. Since their introduction to the market and with the emergence of specialized process equipment, sterilized subassembled syringes have more and more replaced the non-sterile “bulkware” to become the preferred approach for pre-filled syringe filling operations. In the case of sterilized subassembled syringes ready for filling, responsibility for the aforementioned process steps relevant to the injectable product lies within the manufacturer of the subassembled syringes. Following the assembly of the needle shield on syringes with a staked needle or tip caps for the Luer cone version, the subassembled syringes are placed into so called nests. The nests, in turn, are placed into a plastic tub. The syringes in the nest are protected by means of an insert liner and the tub itself is sealed by a sealing lid (which is currently, and so far, primarily achieved using a porous material). Thus, the tub properly sealed with the sealing lid represents the “sterile barrier system”. The sealed tub is then wrapped into a sealable bag and, thus, ready for sterilization, which is current

Scope: This document specifies a packaging system that is used to deliver sterilized subassembled syringes ready for filling in tubs and nests. Downstream processes (processes after filling such as in house/outside transport, reprocessing) can result in specific requirements on the packaging system used to deliver sterilized subassembled syringes ready for filling. However, these requirements are not within the scope of this document. NOTE 1 Glass barrels and sterilized subassembled syringes ready for filling, plunger stoppers, and plastic barrels for injectables are specified in ISO 11040-4, ISO 11040-5 and ISO 11040-6. NOTE 2 ISO 11607-2 addresses validation requirements of sealing and packaging processes for medical devices.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 11040-7-2024 PDF

ISO 11040-7-2024 PDF

$60.00 $120.00