Textiles — Physiological effects — Measurement of thermal and water-vapour resistance under steady-state conditions (sweating guarded-hotplate test)
Introduction: This document is the first of a number of standard test methods in the field of clothing comfort. The physical properties of textile materials which contribute to physiological comfort involve a complex combination of heat and mass transfer. Each can occur separately or simultaneously. They are time- dependent, and can be considered in steady-state or transient conditions. Thermal resistance is the net result of the combination of radiant, conductive and convective heat transfer, and its value depends on the contribution of each to the total heat transfer. Although it is an intrinsic property of the textile material, its measured value can change through the conditions of test due to the interaction of parameters, such as radiant heat transfer with the surroundings. Several methods exist which can be used to measure heat and moisture properties of textiles, each of which is specific to one or the other and relies on certain assumptions for its interpretation. The sweating guarded-hotplate (often referred to as the “skin model”) described in this document is intended to simulate the heat and mass transfer processes which occur next to human skin. Measurements involving one or both processes can be carried out either separately or simultaneously using a variety of environmental conditions, involving combinations of temperature, relative humidity, air speed, and in the liquid or gaseous phase. Hence transport properties measured with this apparatus can be made to simulate differ
Scope: This document specifies methods for the measurement of the thermal resistance and water-vapour resistance, under steady-state conditions, of e.g. fabrics, films, coatings, foams and leather, including multilayer assemblies, for use in clothing, quilts, sleeping bags, upholstery and similar textile or textile-like products. The application of this measurement technique is restricted to a maximum thermal resistance and water- vapour resistance which depend on the dimensions and construction of the apparatus used (e.g. 2 m2·K/W and 700 m2·Pa/W respectively, for the minimum specifications of the equipment referred to in this document). The test conditions used in this document are not intended to represent specific comfort situations, and performance specifications in relation to physiological comfort are not stated.