Textile machinery - Safety requirements - Part 1: Common requirements
Introduction: ISO 11111-1 to ISO 11111-7 were prepared simultaneously by ISO/TC 72 and CEN/TC 214, and adopted under the Vienna Agreement in order to obtain identical standards on technical safety requirements for the design and construction of textile machinery. ISO 11111 as a whole is intended for use by any person concerned with the safety of textile machinery, for example, textile machinery designers, manufacturers and systems integrators. It is also of interest to users of textile machines and safety experts. This part of ISO 11111 is a type C standard as stated in ISO 12100. The various parts of ISO 11111 deal with significant hazards generated by machines used in the textile industry. The machinery concerned and the extent to which hazards are covered are indicated in the scope of this part of ISO 11111. When provisions of this type C standard are different from those which are stated in type A or B standards, the provisions of this type C standard take precedence. For machines or machine equipment not dealt with in the relevant parts of ISO 11111, the designer performs a risk assessment according to ISO 12100 and provides means for reducing the risk from significant hazards. These risk reduction measures that need to be identified by the designer/manufacturer of the machinery by risk assessment are outside the scope of this standard. This part of ISO 11111 contains a summary of safety requirements and/or measures for frequently occurring hazards of textile machinery (see Clause 5)
Scope: This part of ISO 11111 specifies safety requirements for frequently occurring hazards common to the types of textile machinery and the hazards of certain machine elements covered by ISO 11111-2 to ISO 11111-7. The standard series is complemented by the type C standards ISO 9902 (all parts) with respect to noise emission measurement and ISO 23771 with respect to measures for the reduction of noise emissions. This part of ISO 11111 is applicable to machinery plant and related equipment intended to be used in the textile industry for the following purposes: — opening, cleaning, blending, carding, preparation subsequent to carding, spinning and other processing of fibres (staple and filament) and other materials to form yarn or nonwoven material (including felts); — winding, doubling, twisting, texturing, etc., of yarns and the processing of yarns preparatory to weaving and knitting; — weaving, knitting, lace-making and similar utilization of yarn, etc., to form fabric; — forming of braid, cord, strand, rope, twine, net, etc., except take-up reels of stranding and laying machinery; — processing, including the pretreatment, bleaching, dyeing, printing and finishing of fibre, yarn, fabric, braid, cord, etc., and final assembly for dispatch; — piece-dyeing of made-up goods; — finishing of warp and weft knitting, including hosiery, other than assembly of the finished product (e.g. sewing); — manufacturing of carpets by weaving, tufting and other processes. This part of ISO 11111 applies to all machinery, plant and equipment used during the processes listed above, including equipment to enable automated operation of the machines and processes in either free-standing or complex installations, such as pneumatic fibre transportation, but excluding other transportation between the interfaces of the machines. NOTE 1 The standard for a specific textile machine will normally consist of two parts: this part of ISO 11111 and the specific part of ISO 11111 relevant to that machine. However, in the case of nonwoven lines, which are covered by ISO 11111-3, ISO 11111-2, ISO 11111-6 and ISO 11111-7 are also to be taken into account. This part of ISO 11111 does not deal with specific r