Bouteilles à gaz - Compatibilité des matériaux des bouteilles et des robinets avec les contenus gazeux - Partie 2: Matériaux non métalliques
Introduction: This document provides guidance on the compatibility of non-metallic materials used for gas cylinders and gas cylinder valves with the gas contents of the cylinder. Compatibility of metallic materials is covered in ISO 11114-1. Non-metallic materials are very often used for the construction of gas cylinder valves as seals, e.g. O-ring, gland packing, seats or as lubrication products to avoid friction. They are also commonly used to ensure sealing of the valve/cylinder connection. For gas cylinders, they are sometimes used as an internal coating or as a liner for composite materials. Non-metallic materials not in contact with the gas are not covered by this document. This document is based on current international experience and knowledge. Some data are derived from experience involving a mixture of the gas concerned with a dilutant, where no data for single component gases were available. This document has been written so that it is suitable to be referenced in the UN Model Regulations[7]. ISO 11114-2:2021(E) © ISO 2021 – All rights reserved
Scope: This document gives guidance on the selection and evaluation of compatibility between non-metallic materials for gas cylinders and valves and the gas contents. It is also applicable to tubes, pressure drums and bundles of cylinders. This document covers composite and laminated materials used for gas cylinders. It does not include ceramics, glasses and adhesives. This document considers the influence of the gas in changing the material and mechanical properties (e.g. chemical reaction or change in physical state). The basic properties of the materials, such as mechanical properties required for design purposes (normally available from the materials supplier), are not considered. Other aspects, such as quality of delivered gas, are not considered. The compatibility data given are related to single component gases but can be applicable to gas mixtures. This document does not apply to cryogenic fluids (this is covered in ISO 21010).