Gas cylinders — Design, construction and testing of refillable composite gas cylinders and tubes — Part 1: Hoop wrapped fibre reinforced composite gas cylinders and tubes up to 450 l
Introduction: The purpose of this document is to provide a specification for the design, manufacture, inspection and testing of cylinders for worldwide usage. The objective is to balance design and economic efficiency against international acceptance and universal utility. This document aims to eliminate the concern about climate, duplicate inspection and restrictions currently existing because of lack of definitive International Standards and is not to be construed as reflecting on the suitability of the practice of any nation or region. This document addresses the general requirements on design, construction and initial inspection and testing of pressure receptacles of the Recommendations on the transport of dangerous goods: Model regulations developed by the United Nations[15]. vi © ISO 2020 – All rights reserved
Scope: This document specifies minimum requirements for the material, design, construction and workmanship, manufacturing processes, examination and testing at time of manufacture for: — type 2 composite hoop wrapped cylinders or tubes with a load-sharing metal liner and composite reinforcement on the cylindrical portion only; — water capacities up to 450 l; — the storage and conveyance of compressed or liquefied gases; — cylinders and tubes with composite reinforcement of carbon fibre, aramid fibre or glass fibre (or a mixture thereof) within a matrix or steel wire to provide circumferential reinforcement; — a minimum design life of 15 years. This document does not address the design, fitting, and performance of removable protective sleeves. NOTE 1 References to cylinders in this document include composite tubes if appropriate. NOTE 2 ISO 11439 applies to cylinders intended for use as fuel containers on natural gas vehicles and ISO 11623 covers periodic inspection and re-testing of composite cylinders.