ISO 11125-9-2021 PDF

ISO 11125-9-2021 PDF

Preparation of steel substrates before application of paints and related products-Test methods for metallic blast-cleaning abrasives-Part 9: Wear testing and performance

$71.50 $143.00 -50%
Product Code: ISO 11125-9
Stock In Stock
Edition: 1ST
Published: 08/2021
Number of Pages: 20
File Size: 1 file, 1 Byte

Available Options

Product Description

Preparation of steel substrates before application of paints and related products — Test methods for metallic blast-cleaning abrasives — Part 9: Wear testing and performance

Introduction: This document is a part of the ISO 11125 series that specifies test methods for metallic blast-cleaning abrasives. During blast-cleaning, metallic abrasives are subjected to repeated impacts on the substrate to be prepared. These mechanical impacts result in abrasive material fatigue until particles breakdown. The service life of the metallic blast-cleaning abrasives is influenced by: — the type of abrasive, in particular, its size and shape, its resilience, its hardness and its internal defects; — the hardness and the surface conditions of the substrate to be prepared; — the blasting machine and its settings. The principle of an abrasive service life testing machine is based on a high number of impacts between a representative sample of the abrasive to be tested and a given target. Several testing machines exist on the market and depending on their design, the service life obtained under laboratory conditions may or may not be comparable to field operation. It is important that the user is aware of the different parameters and the respective adjustability. The parameters of the testing machines can vary from one machine to another and therefore can result in different test results. In general, the effect of wear and consumption are tested. Special arrangements may be required for specific test procedures. The results can be used for comparison purposes (quality inspection) or for monitoring (quality control) of the deliveries for uniformity. © ISO 2021 – All rights reserved

Scope: This document specifies three procedures to test the service life of a blast-cleaning abrasive under laboratory conditions. The performance of an abrasive is also measured by its ability to clean, via transmission of kinetic energy to the substrate in the blasting process. This document also specifies the procedures that can be performed in the same testing machines to help evaluate abrasive performance under laboratory conditions. This document applies to the testing of virgin metallic blasting media in the delivery state by centrifugal blasting under laboratory conditions.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 11125-9-2021 PDF

ISO 11125-9-2021 PDF

$71.50 $143.00