Corrosion of Metals and Alloys - Alternate Immersion Test in Salt Solution
Introduction: Corrosion of metals is influenced by factors which can vary significantly with environmental conditions. Therefore, corrosion resistance determined for metals during alternate immersion testing as described in this document can vary greatly with the test solution selected, the temperature during immersion and the temperature and humidity during the drying periods of the test. Consequently, the result of an alternate immersion corrosion test is not taken as an indication of the corrosion resistance of the metal tested in all the different service environments where the metal can be used. Nevertheless, results obtained by the method described in this document can indicate the relative corrosion resistance of different metals under in-service conditions, in particular when the service environment is similar to the test solution selected. The method can also be used to test metals under an applied tensile stress. © ISO 2017 – All rights reserved
Scope: This document specifies a method for assessing the corrosion resistance of metals by an alternate immersion test in salt solution, with or without applied stress. The test is particularly suitable for quality control during the manufacture of metals including aluminium alloys and ferrous materials, and also for assessment purposes during alloy development. Depending upon the chemical composition of the test solution, the test can be used to simulate the corrosive effects of marine splash zones, de-icing fluids and acid salt environments. The term “metal” as used in this document includes metallic materials with or without corrosion protection. This document is applicable to — metals and their alloys, — certain metallic coatings (anodic and cathodic with respect to the substrate), — certain conversion coatings, — certain anodic oxide coating, and — organic coatings on metals.