Lasers et équipements associés aux lasers - Méthodes d'essai des largeurs du faisceau, angles de divergence et facteurs de limite de diffraction - Partie 2: Faisceaux astigmatiques généraux
Introduction: The propagation properties of laser beams can be characterized by ten independent parameters when applying the method of second order moments (see ISO/TR 11146-3). Most laser beams need few parameters for a complete description due to their higher symmetry. Lasers emit beams which are stigmatic or simple astigmatic due to their resonator design. ISO 11146-1 describes the measurement methods for stigmatic and simple astigmatic beams while this document deals with the measurement procedures for general astigmatic beams. This document is applicable to beams of unknown type. Beam characterization, based on the method of second order moments as described in ISO 11146-1 and this document, is only valid within the paraxial approximation. The theoretical description of beam characterization and propagation as well as the classification of laser beams is given in ISO/TR 11146-3, which is a Technical Report. The procedures for background subtraction and offset correction are also given in ISO/TR 11146-3. In ISO 11146, the second order moments of the power (energy) density distribution function are used for the determination of beam widths. If problems are experienced in the direct measurements of these quantities, other indirect methods of measurement of second order moments may be used as long as comparable results are achievable. In ISO/TR 11146-3, three alternative methods for beam width measurement and their correlation with the method used in this document are described. These met
Scope: This document specifies methods for measuring beam widths (diameter), divergence angles and beam propagation ratios of laser beams. This document is applicable to general astigmatic beams or unknown types of beams. For stigmatic and simple astigmatic beams, ISO 11146-1 is applicable. Within this document, the description of laser beams is accomplished by means of the second order moments of the Wigner distribution rather than physical quantities such as beam widths and divergence angles. However, these physical quantities are closely related to the second order moments of the Wigner distribution. In ISO/TR 11146-3, formulae are given to calculate all relevant physical quantities from the measured second order moments.