Plastics piping systems for renovation of underground non-pressure drainage and sewerage networks - Part 7: Lining with spirally-wound pipes
Introduction: This document is a part of a System Standard for plastics piping systems of various materials used for the renovation of existing pipelines in a specified application area. System Standards for renovation deal with the following applications: — ISO 11296, Plastics piping systems for renovation of underground non-pressure drainage and sewerage networks (this application); — ISO 11297, Plastics piping systems for renovation of underground drainage and sewerage networks under pressure; — ISO 11298, Plastics piping systems for renovation of underground water supply networks; — ISO 11299, Plastics piping systems for renovation of underground gas supply networks. These System Standards are distinguished from those for conventionally installed plastics piping systems by the requirement to verify certain characteristics in the “as-installed condition”, after site processing. This is in addition to specifying requirements for plastics piping system components “as manufactured”. Each of the System Standards comprises a — Part 1: General and all applicable renovation technique family-related parts, which for non-pressure drainage and sewerage networks include or potentially include the following: — Part 2: Lining with continuous pipes; — Part 3: Lining with close-fit pipes; — Part 4: Lining with cured-in-place pipes; — Part 5: Lining with discrete pipes; — Part 7: Lining with spirally-wound pipes (this document); — Part 8: Lining with pipe segments; — Part 9: Lining with a rigidly ancho
Scope: This document, in conjunction with ISO 11296-1, specifies requirements and test methods for pipes which are formed on site by spirally winding and jointing a pre-manufactured profiled plastics strip, or a profiled plastics strip and integral locking joiner strip, and used for the renovation of underground non-pressure drainage and sewerage networks. It applies to spirally-wound pipes of fixed or variable diameter made of profiled plastics strips, with or without steel stiffening elements, and installed by one of two methods. The first method employs a dedicated winding machine in front of the open end of an existing pipeline, e.g. in a manhole. The pipes thus formed are simultaneously inserted into the existing pipeline by the winding forces, and by certain techniques can also be expanded in diameter after or during insertion. The second method employs a dedicated winding machine which forms the pipe as it traverses the existing pipeline from one manhole to the next. It applies to profiled plastics strips of unplasticized poly(vinyl chloride) (PVC U) with integral locking mechanism, or of high density polyethylene (HDPE) with integrally welded joints.