ISO 11298-3-2018 PDF

ISO 11298-3-2018 PDF

Plastics piping systems for renovation of underground water supply networks - Part 3: Lining with close-fit pipes

$89.50 $179.00 -50%
Product Code: ISO 11298-3
Stock In Stock
Edition: 2ND
Published: 09/2018
Number of Pages: 26
File Size: 1 file, 1 Byte

Available Options

Product Description

Systèmes de canalisations en plastique pour la rénovation des réseaux enterrés d'alimentation en eau - Partie 3: Tubage par tuyau continu sans espace annulaire

Introduction: This document is a part of a System Standard for plastics piping systems of various materials used for the renovation of existing pipelines in a specified application area. System Standards for renovation deal with the following applications: — ISO 11296, Plastics piping systems for renovation of underground non-pressure drainage and sewerage networks; — ISO 11297, Plastics piping systems for renovation of underground drainage and sewerage networks under pressure; — ISO 11298, Plastics piping systems for renovation of underground water supply networks (this document); — ISO 11299, Plastics piping systems for renovation of underground gas supply networks. These System Standards are distinguished from those for conventionally installed plastics piping systems by the requirement to verify certain characteristics in the “as-installed” condition, after site processing. This is in addition to specifying requirements for plastics piping systems components “as manufactured”. Each of the System Standards comprises a: — Part 1: General and all applicable renovation technique family-related parts, which for water supply networks include or potentially include the following: — Part 2: Lining with continuous pipes — Part 3: Lining with close-fit pipes (this document) — Part 4: Lining with cured-in-place pipes — Part 5: Lining with discrete pipes — Part 6: Lining with adhesive-backed hoses — Part 10: Lining with sprayed polymeric materials — Part 11: Lining with inserted hoses The requirem

Scope: This document, in conjunction with ISO 11298-1, specifies requirements and test methods for close-fit lining systems intended to be used for the renovation of water supply networks, which transport water intended for human consumption, including raw water intake pipelines. It applies to pipes and fittings, as manufactured, as well as to the installed lining system. It is applicable to polyethylene (PE) pipes of either solid wall single layer or co-extruded layer construction, which is reduced in the factory or on site to provide a close-fitting independent or interactive pressure pipe liner, as well as associated fittings and joints for the construction of the lining system. It is not applicable to PE coated pipes having a peelable, contiguous, thermoplastic additional layer on the outside of the pipe. It is applicable to PE pipes, fittings and assemblies intended to be used at an operating temperature of 20 °C as the reference temperature. NOTE For applications operating at constant temperatures greater than 20 °C and up to 40 °C, see ISO 4427-1:2007, Annex A.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 11298-3-2018 PDF

ISO 11298-3-2018 PDF

$89.50 $179.00