ISO 11352-2025 PDF

ISO 11352-2025 PDF

Water quality-Estimation of measurement uncertainty based on validation and quality control data

$129.00 $258.00 -50%
Product Code: ISO 11352
Stock In Stock
Edition: 2.
Published: 09/2025
Number of Pages: 46
File Size: 1 file, 3 Bytes

Available Options

Product Description

Water quality — Estimation of measurement uncertainty based on validation and quality control data

Introduction: The basic principles of the estimation of measurement uncertainty are set out in ISO/IEC Guide 98-3.[1] There are several ways of estimating measurement uncertainty depending on the purpose of the estimation and the available data; Eurolab TR 1/2007[2] gives an overview of the main approaches. This document specifies a set of procedures to enable laboratories to estimate the measurement uncertainty of their results, using an approach based on validation and quality control data. Validation data can be used for first estimates of the measurement uncertainty, but should later be confirmed with data from quality control, when the method is in routine use. It is structured in a way that is applicable to analysts that do not have a thorough understanding of metrology or statistics. Nordtest TR 537[3] has been used as a basis for developing this document. The approach taken is “top-down”, contrary to the mainly “bottom-up” strategy adopted in ISO/IEC Guide 98-3[1]. It is statistically acceptable to combine the uncertainty components associate with within-laboratory reproducibility for random error and the uncertainty associated the bias for systematic error into a single measure of uncertainty. The sources of data for this approach are validation and analytical quality control. The experimental approach specified in this document enables a good coverage of the sources of variation observed during routine use of the analytical method. © ISO 2025 – All rights reserved

Scope: This document specifies approaches for the estimation of measurement uncertainty of chemical and physicochemical methods in single laboratories based on validation data and quality control data obtained within the field of water analysis. However, this approach can also be used in many other areas of chemical analysis. NOTE 1 The principles of the estimation of uncertainty specified in this document are consistent with the principles described in ISO/IEC Guide 98-3. In this document, the quantification of measurement uncertainty relies on performance characteristics of a measurement procedure obtained from validation and the results of internal and external quality control. NOTE 2 The approaches specified in this document are mainly based on Nordtest TR 537[3], but also QUAM[4], and Eurolab TR 1/2007[2]. NOTE 3 This document only addresses the evaluation of measurement uncertainty for results obtained from quantitative measurement procedures. The uncertainties associated with results obtained from qualitative procedures are not considered.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 11352-2025 PDF

ISO 11352-2025 PDF

$129.00 $258.00