Petroleum and related products — In-servicing of steam, gas and combined cycle turbines lubricating oils — Guidance and requirements
Introduction: The in-service monitoring of turbine oils is largely recognized by the power generation industry as necessary to insure long and trouble-free operation of turbines. There are three main types of stationary turbines used in power generation plants: steam turbines, gas turbines and combined cycle turbines. The combined cycle turbines consist of two types: — the first type associates a gas turbine with a steam turbine, with separated lubricating circuits; — the second type is called a single shaft combined cycle turbine, in which the steam and the gas turbines are on the same shaft and are lubricated with the same oil. The lubrication requirements of gas turbines and steam turbines are quite similar, but there are some big differences. Gas turbine oils are submitted to localized hot spots and water contamination is less likely. Gas turbine oils have shorter service life than steam turbine oils, which can range from 10 to 20 years, depending on the top-up level. The lifetime of gas turbine oils can range from five to 10 years, or more. The values of the various characteristics mentioned in this document are purely indicative. For proper interpretation of the results, many factors should be taken into account, such as the type of equipment, design of the lubricating oil circuit and top-up level. It is expected that the manufacturer’s instructions are followed. This document is intended to: — help power equipment operators evaluate the conditions of the oil in their equipment and m
Scope: This document provides guidance and requirements for the maintenance in service of mineral oils used as lubricating oils and control fluids used to lubricate steam, gas and combined cycle turbines in service. This document is applicable to lubricants classified in ISO 6743-5 and specified in ISO 8068, except the grades TSD, TGD and TCD (phosphate esters) for which ISO 11365 is more relevant, and the grades TGCE, THA, THCH, THCE and THE. This document also gives guidance and requirements with respect to the corrective actions that are taken to maximize service life.