Protective clothing for users of handheld chainsaws — Part 6: Performance requirements and test methods for upper body protectors
Introduction: This document forms part of a series concerned with personal protective equipment (PPE) designed to protect against the risks arising from the use of hand-held chainsaws primarily constructed for cutting wood. Accidents occur due to a number of complex reasons, but a common factor is incorrect use of the chainsaw. The importance of correct training and proper use of a chainsaw in preventing accidents cannot be underestimated. All parts of the upper body have been shown to be at risk when using a chainsaw. In this document, specifications for the protective coverage and performance of the upper body protectors are given. No PPE can ensure a 100 % protection against cutting from a hand-held chainsaw. Nevertheless, experience has shown that it is possible to design PPE that offers a certain degree of protection. Different functional principles may be applied in order to give protection. These include: a) chain slipping: on contact the chain does not cut the material; b) clogging: fibres are drawn by the chain into the drive sprocket and block chain movement; c) chain braking: fibres have a high resistance to cutting and absorb rotational energy, thereby reducing the chain speed. Often more than one principle is applied in chainsaw protective clothing. Upper body protectors in accordance with this document are meant to be used while working off the ground, and where risk assessment shows that there is a significant risk of being cut by the moving chain on the upper part of the bo
Scope: This document specifies the performance requirements, test methods, design requirements, identification and marking information for upper body protectors that offer protection against cutting by hand-held chainsaws. It also specifies procedures for sampling and pre-treatment of upper body protectors, the measurement of the protective coverage, the apparatus and test methods for assessing resistance to cutting, and the practical performance test for evaluating ergonomic properties. Guidance on chainsaw use and the selection of appropriate upper body protectors is given in Annex A.