ISO 11484-2019 PDF

ISO 11484-2019 PDF

Steel products-Employer's qualification system for nondestructive testing (NDT) personnel

$96.50 $193.00 -50%
Product Code: ISO 11484
Stock In Stock
Edition: 3RD
Published: 04/2019
Number of Pages: 26
File Size: 1 file, 1 Byte

Available Options

Product Description

Steel products — Employer's qualification system for nondestructive testing (NDT) personnel

Introduction: This document concerns the qualification of personnel engaged in the non-destructive testing (NDT) of steel products. It has been recognized that within the steel industry worldwide there is a predominance of semi- automated/automated NDT equipment in use by NDT personnel to establish product integrity, as opposed to principally manual methods adopted in other industrial sectors. As a result, this document permits the employer qualification, subject to certain restrictions. In the preparation of this document, the requirements of ISO 9712 have been taken into account or adopted where they apply. However, it should be noted that the primary job-specific nature of the NDT tasks performed by NDT personnel on steel products is outside the scope of ISO 9712 job-specific training performed by the employer (see ISO 9712:2012, 3.13). Thus, in the context of this document, the requirements of ISO 9712 should not be taken as basic or additional minimum requirements. This does not preclude the right of any individual to apply for and obtain qualification/certification in conformity with ISO 9712 as may be appropriate in another sector. It is recognized that this document may be applied to steel product sectors and other specific product sectors, as appropriate. For product sectors, refer to ISO 9712:2012, A.2. © ISO 2019 – All rights reserved

Scope: This document specifies an employer’s qualification system for non-destructive testing (NDT) personnel performing the testing of the following steel products under the employer’s responsibility: a) tubes/pipes (seamless or welded); b) flat products, long products, rails, bars, sections, rods and wires. This document specifies qualification requirements for the competence of Level 1 and Level 2 NDT personnel to execute specific tasks in the NDT of steel products. The qualification is issued by the employer for a specific steel product and a specific test method. This document is applicable to NDT personnel performing predominantly the automated testing of steel products, using any of the following NDT methods: a) eddy current testing (ET); b) leak testing (LT); c) liquid penetrant testing (PT); d) magnetic testing (MT); e) radiographic testing (RT); f) ultrasonic testing (UT); g) visual testing (VT).

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 11484-2019 PDF

ISO 11484-2019 PDF

$96.50 $193.00