ISO 11662-2-2014 PDF

ISO 11662-2-2014 PDF

Mobile cranes - Experimental determination of crane performance - Part 2: Structural competence under static loading

$129.00 $258.00 -50%
Product Code: ISO 11662-2
Stock In Stock
Edition: 1ST
Published: 11/01/2014
Number of Pages: 48
File Size: 1 file, 1 Byte

Available Options

Product Description

Mobile cranes - Experimental determination of crane performance - Part 2: Structural competence under static loading

Introduction: When design calculations are made for mobile cranes, they are based on an ideal model in which all members and components are perfectly straight and fabrication has been exact. For tension members and members subjected to bending, the difference between the real crane and the ideal model is usually not significant. But, for compression members subject to column buckling, an allowance for deviation in straightness and fabrication is necessary. When mobile cranes are tested non-destructively by means of strain gauges, the stresses determined intrinsically include these effects of deviations in straightness and accuracy of fabrication. This test method is intended to describe the approximate maximum loading conditions to which any component of the entire load-supporting structure of a crane is subjected (See Annex D). In some cases, a more severe loading condition(s) can be indicated by analysis. In these cases, the more severe condition(s) can be added to or substituted for the specified test loading condition(s). This test method also classifies stress areas as Types I (Uniform Stress Areas), II (Stress Concentration Areas), III (Column Buckling Areas), and IV (Local Plate Buckling Areas; see Clause 10), and defines limits for each class. Results can be used to correlate boom system calculation results for Class III stress areas as given by boom system calculations. Test results for Class I stress areas throughout the structure can be used to check any available calculations.

Scope: This part of ISO 11662 applies to mobile construction-type lifting cranes utilizing a) rope supported, lattice boom attachment or lattice boom, and fly jib attachment (see Annex E, Figure E.3), b) rope supported, mast attachment and mast mounted boom, and fly jib attachment (see Annex E, Figures E.1 and E.2), or c) telescoping boom attachment or telescopic boom and fly jib attachment (see Figure E.4). Mobile crane manufacturers can use this part of ISO 11662 to verify their design for the mobile crane types illustrated in Figures E.1 through E.4. This test method is to provide a systematic, non-destructive procedure for determining the stresses induced in crane structures under specified conditions of static loading through the use of resistance- type electric strain gauges, and to specify appropriate acceptance criteria for specified loading conditions.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 11662-2-2014 PDF

ISO 11662-2-2014 PDF

$129.00 $258.00