ISO 1179-2-2022 PDF

ISO 1179-2-2022 PDF

Connections for general use and fluid power-Ports and stud ends with ISO 228-1 threads with elastomeric or metal-to-metal sealing-Part 2: Heavy-duty (S series) and light-duty (L series) stud ends with elastomeric sealing (type E)

$48.00 $96.00 -50%
Product Code: ISO 1179-2
Stock In Stock
Edition: 3.
Published: 11/2022
Number of Pages: 16
File Size: 1 file, 1 Byte

Available Options

Product Description

Connections for general use and fluid power — Ports and stud ends with ISO 228-1 threads with elastomeric or metal-to-metal sealing — Part 2: Heavy-duty (S series) and light-duty (L series) stud ends with elastomeric sealing (type E)

Introduction: In fluid power systems, power is transmitted and controlled through a fluid (liquid or gas) under pressure within a circuit. In general applications, a fluid can be conveyed under pressure. Components are connected through their threaded ports by fluid conductor connectors to tubes and pipes or to hose fittings and hoses. For threaded ports and stud ends specified in new designs in hydraulic fluid power applications, the ISO 6149 series should be used because these International Standards specify ports and stud ends with metric threads and O-ring sealing, and because the use of only one system is preferred. It is further recommended that threaded ports and stud ends in accordance with the ISO 1179 series, ISO 9974 series and ISO 11926 series should not be used for new designs in hydraulic fluid power applications (these International Standards are maintained because they specify ports and stud ends that are currently used in hydraulic systems worldwide). For threaded ports and stud ends specified in new designs in pneumatic fluid power applications, ISO 16030 should be used, except where products are to interface with ISO 7-1 threads, because the use of only one system is preferred. It is further recommended that threaded ports and stud ends in accordance with the ISO 1179 series should not be used for new designs in pneumatic fluid power applications (these International Standards are maintained because they specify ports and stud ends that are currently used in pneumatic sy

Scope: This document specifies the dimensions, performance requirements and test procedures for heavy- duty (S series) and light-duty (L series) stud ends with threads, and the elastomeric sealing (type E) that is used with them as defined in ISO 228-1. Heavy-duty (S series) stud ends with type E sealing in accordance with this document can be used at working pressures up to 63 MPa (630 bar). Light-duty (L series) stud ends with type E sealing in accordance with this document can be used at working pressures up to 25 MPa (250 bar). The permissible working pressure depends upon size, materials, design, working conditions, application, etc. This document is applicable to connectors detailed in ISO 8434-1, ISO 8434-2 and ISO 8434-6. NOTE The Introduction gives recommendations for ports and stud ends to be used for new designs in hydraulic and pneumatic fluid power applications.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 1179-2-2022 PDF

ISO 1179-2-2022 PDF

$48.00 $96.00