ISO 11794-2017 PDF

ISO 11794-2017 PDF

Copper, lead, zinc and nickel concentrates - Sampling of slurries

$129.00 $258.00 -50%
Product Code: ISO 11794
Stock In Stock
Edition: 2ND
Published: 06/2017
Number of Pages: 50
File Size: 1 file, 2 Bytes

Available Options

Product Description

Copper, lead, zinc and nickel concentrates - Sampling of slurries

Scope: This document sets out the basic methods for sampling particulate material that is mixed with a liquid, usually water, to form a slurry. In industry and in the mining and mineral processing literature, slurry is also referred to as pulp, but this term is not used in this document. At very high ratios of fine particulate solids to liquids where material assumes a soft plastic form, the mixture is correctly termed as a paste. Sampling of pastes is not covered in this document. The procedures described in this document apply to sampling of particulate materials that are transported in moving streams as slurries, but not pressurized slurries. These streams may fall freely or be confined in pipes, launders, flumes, sluices, spirals or similar channels. Sampling of slurries in stationary situations, such as a settled or even a well-stirred slurry in a holding vessel or dam, is not recommended and is not covered in this document. This document describes procedures that are designed to provide samples representative of the slurry solids and particle-size distribution of the slurry under examination. After draining the slurry sample of fluid and measuring the fluid volume, damp samples of the contained particulate material in the slurry are available for drying (if required) and measurement of one or more characteristics in an unbiased manner and with a known degree of precision. The characteristics are measured by chemical analysis, physical testing or both. The sampling methods described are applicable to slurries that require inspection to verify compliance with product specifications, determination of the value of a characteristic as a basis for settlement between trading partners or estimation of a set of average characteristics and variances that describes a system or procedure. Provided that flow rates are not too high, the reference method against which other sampling procedures are compared is one where the entire stream is diverted into a vessel for a specified time or volume interval. This method corresponds to the stopped-belt method described in ISO 12743.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 11794-2017 PDF

ISO 11794-2017 PDF

$129.00 $258.00