ISO 11819-1-2023 PDF

ISO 11819-1-2023 PDF

Acoustics-Measurement of the influence of road surfaces on traffic noise-Part 1: Statistical pass-by method

$60.00 $120.00 -50%
Product Code: ISO 11819-1
Stock In Stock
Edition: 2.
Published: 02/2023
Number of Pages: 58
File Size: 1 file, 4 Bytes

Available Options

Product Description

Acoustique - Mesurage de l’influence des revêtements de chaussées sur le bruit émis par la circulation - Partie 1: Méthode statistique au passage

Introduction: The emission of road traffic noise greatly depends on road surface characteristics, notably on texture and porosity; the latter due to the flow resistivity of the air voids. Both these characteristics influence the generation of tyre/road noise and, in addition, the porosity can influence the emission of sound, particularly when the emission takes place close to the surface. Power unit noise, which is usually generated at a greater height above the road surface than tyre/road noise, can also be affected during emission by the porosity characteristics of the road surface. These effects lead to differences in sound levels, associated with a given traffic flow and composition, from different road surfaces of up to 15 dB, which can have a substantial impact on the environmental acoustic quality alongside a road. It is therefore important to be able to measure this influence by a standardized method and to arrive at a quantitative ranking of road surfaces with respect to traffic noise. This document offers such a method, the objective of which is to satisfy a need expressed by road planners, road administrators, contractors, manufacturers of so-called "low-noise surfaces" and by other parties concerned with the prediction and control of road traffic noise. © ISO 2023 – All rights reserved

Scope: This document specifies a method of comparing traffic noise on different road surfaces for various compositions of road traffic for the purpose of evaluating different road surface types. Sound levels representing either light or heavy vehicles at selected speeds are assigned to a certain road surface. The method is applicable to traffic travelling at constant speed, i.e. free-flowing conditions at posted speeds of 50 km/h and upwards. For conditions where traffic is not free flowing, such as at junctions and where the traffic is congested, the method is not applicable. A standard method for comparing the noise characteristics of road surfaces gives road and environment authorities a tool for establishing common practices or limits regarding the use of road surfaces meeting certain noise criteria. However, it is not within the scope of ISO 11819 (all parts) to suggest such criteria. The statistical pass-by (SPB) method is suitable for use for the following main purposes: — to classify road surfaces according to their influence on traffic noise (surface classification); — to assist in verifying conformity of production of road surfaces; — to evaluate acoustic performance of road surfaces throughout operation relative to new condition; — to evaluate the influence of different road surfaces on traffic noise at sites irrespective of condition and service time; — to evaluate acoustic performance of a road surface relative to a reference surface. Due to practical restrictions, the method cannot be applied at all possible locations. However, the backing board method can allow some locations to be tested that were not previously acceptable. Clause 5 gives a general description of the SPB method.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 11819-1-2023 PDF

ISO 11819-1-2023 PDF

$60.00 $120.00