ISO 11855-8-2023 PDF

ISO 11855-8-2023 PDF

Building environment design-Design, dimensioning, installation and control of embedded radiant heating and cooling systems-Part 8: Electrical heating systems

$48.00 $96.00 -50%
Product Code: ISO 11855-8
Stock In Stock
Edition: 1.
Published: 12/2023
Number of Pages: 16
File Size: 1 file, 1 Byte

Available Options

Product Description

Building environment design — Design, dimensioning, installation and control of embedded radiant heating and cooling systems — Part 8: Electrical heating systems

Introduction: The radiant heating and cooling system consists of heat emitting/absorbing, heat supply, distribution, and control systems. The ISO 11855 series deals with the embedded surface heating and cooling system that directly controls heat exchange within the space. It does not include the system equipment itself, such as heat source, distribution system and controller. The ISO 11855 series addresses an embedded system that is integrated with the building structure. Therefore, the panel system with open air gap, which is not integrated with the building structure, is not covered by this series. The ISO 11855 series can be applied to systems that use not only water but also other liquids or electricity as a heating or cooling medium. The object of the ISO 11855 series is to provide criteria to effectively design embedded systems. To do this, it presents comfort criteria for the space served by embedded systems, heat output calculation, dimensioning, dynamic analysis, installation, operation, and control method of embedded systems. The following is a summary of the ISO 11855 parts: — ISO 11855-1 specifies the comfort criteria which should be considered in designing embedded radiant heating and cooling systems, since the main objective of the radiant heating and cooling system is to satisfy thermal comfort of the occupants. — ISO 11855-2 provides steady-state calculation methods for determination of the heating and cooling capacity. — ISO 11855-3 specifies design and dimensioning method

Scope: This document specifies procedures and conditions to enable the heat flux in electrical surface heating systems to be determined relative to the medium differential temperature for systems. The determination of thermal performance electrical surface heating systems and their conformity to this document is carried out by calculation in accordance with design documents and a model. This enables a uniform assessment and calculation surface heating systems. The surface temperature and the temperature uniformity of the heated surface, nominal heat flux density between electrical heated layer and space are given as the result. The ISO 11855 series is applicable to water based embedded surface heating and cooling systems in residential, commercial and industrial buildings1). The methods apply to systems integrated into the wall, floor or ceiling construction without any open-air gaps. It does not apply to ceiling mounted panel systems with open air gaps which are not integrated into the building structure. The ISO 11855 series also applies, as appropriate, to the use of fluids other than water as a heating or cooling medium. The ISO 11855 series is not applicable for testing of systems. The methods do not apply to heated or chilled ceiling panels or beams.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 11855-8-2023 PDF

ISO 11855-8-2023 PDF

$48.00 $96.00