ISO 11952-2019 PDF

ISO 11952-2019 PDF

Surface chemical analysis-Scanningprobe microscopy-Determination of geometric quantities using SPM: Calibration of measuring systems

$145.50 $291.00 -50%
Product Code: ISO 11952
Stock In Stock
Edition: 1ST
Published: 05/2019
Number of Pages: 70
File Size: 1 file, 7 Bytes

Available Options

Product Description

Surface chemical analysis — Scanningprobe microscopy — Determination of geometric quantities using SPM: Calibration of measuring systems

Introduction: The progress of miniaturization in semiconductor structuring, together with the rapid advance of many diverse applications of nanotechnology in industrial processes, calls for reliable and comparable quantitative dimensional measurements in the micro- and submicrometre range[9]. Currently, a measurement resolution, in or below the nanometre region, is frequently required. Conventional optical or stylus measurement methods or coordinate measuring systems are not able to offer this level of resolution. For this reason, scanning-probe microscopes (SPMs) are increasingly employed as quantitative measuring instruments. Their use is no longer confined only to research and development, but has been extended to include industrial production and inspection. For this category of measuring instrument, standardized calibration procedures need to be developed, as have already been established, for example, for contact stylus instruments (see ISO 12179). For efficient and reliable calibration of SPMs to be carried out, the properties of the measurement standards used need to be documented and accounted for in the calibration (see Figure 1). At the same time, the procedure for the calibration should be clearly defined. Only if this prerequisite is satisfied will it be possible to perform traceable measurements of geometrical quantities. NOTE The calibration of a user’s SPM by means of traceable calibrated measurement standards is the object of this document (done by the user). Figure 1 — Tr

Scope: This document specifies methods for characterizing and calibrating the scan axes of scanning-probe microscopes (SPMs) for measuring geometric quantities at the highest level. It is applicable to those providing further calibrations and is not intended for general industry use, where a lower level of calibration might be required. This document has the following objectives: — to increase the comparability of measurements of geometrical quantities made using SPMs by traceability to the unit of length; — to define the minimum requirements for the calibration process and the conditions of acceptance; — to ascertain the instrument's ability to be calibrated (assignment of a “calibrate-ability” category to the instrument); — to define the scope of the calibration (conditions of measurement and environments, ranges of measurement, temporal stability, transferability); — to provide a model, in accordance with ISO/IEC Guide 98-3, to calculate the uncertainty for simple geometrical quantities in measurements using an SPM; — to define the requirements for reporting results.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 11952-2019 PDF

ISO 11952-2019 PDF

$145.50 $291.00