ISO 11961-2018 PDF

ISO 11961-2018 PDF

Petroleum and natural gas industries - Steel drill pipe

$13.00 $26.00 -50%
Product Code: ISO 11961
Stock In Stock
Edition: 3RD
Published: 10/2018
Number of Pages: 120
File Size: 1 file, 4 Bytes

Available Options

Product Description

Petroleum and natural gas industries - Steel drill pipe

Introduction: Users of this document are advised that further or differing requirements might be needed for individual applications. This document is not intended to inhibit a vendor from offering, or the purchaser from accepting, alternative equipment or engineering solutions for the individual application. This may be particularly applicable where there is innovative or developing technology. Where an alternative is offered, the vendor can identify any variations from this document and provide details. © ISO 2018 – All rights reserved

Scope: This document specifies the technical delivery conditions for steel drill-pipes with upset pipe-body ends and weld-on tool joints for use in drilling and production operations in petroleum and natural gas industries for three product specification levels (PSL-1, PSL-2 and PSL-3). The requirements for PSL-1 form the basis of this document. The requirements that define different levels of standard technical requirements for PSL-2 and PSL-3 are in Annex G. This document covers the following grades of drill-pipe: — grade E drill-pipe; — high-strength grades of drill-pipe, grades X, G and S; — enhanced H2S resistance drill pipe, grades D and F. A typical drill-pipe configuration is given, showing main elements and lengths (see Figure B.1). The main dimensions and masses of the grades of drill-pipe are given in both SI units (see Table A.1) and in USC units (see Table C.1). This document can also be used for drill-pipe with tool joints not specified by ISO or API standards. By agreement between purchaser and manufacturer, this document can also be applied to other drill- pipe body and/or tool-joint dimensions. This document lists supplementary requirements that can optionally be agreed between purchaser and manufacturer, for testing, performance verification and non-destructive examination (see Annex E). This document does not consider performance properties, nor performance degradation of the product when in service. NOTE 1 In this document, drill-pipe is designated by label 1, label 2, grade of material (E, X, G, S, D and F), upset type and type of rotary shouldered connection. Designations are used for the purpose of identification in ordering. NOTE 2 Reference can be made to ISO 10424-2 or API Spec 7-2 for the detailed requirements for the threading of drill-pipe tool joints. NOTE 3 Reference can be made to API RP 7G for the performance properties of the drill-pipe.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 11961-2018 PDF

ISO 11961-2018 PDF

$13.00 $26.00