ISO 11992-1-2019 PDF

ISO 11992-1-2019 PDF

Road vehicles-Interchange of digital information on electrical connections between towing and towed vehicles-Part 1: Physical and data-link layers

$96.50 $193.00 -50%
Product Code: ISO 11992-1
Stock In Stock
Edition: 3RD
Published: 05/2019
Number of Pages: 32
File Size: 1 file, 3 Bytes

Available Options

Product Description

Road vehicles — Interchange of digital information on electrical connections between towing and towed vehicles — Part 1: Physical and data-link layers

Introduction: The ISO 11992 series specifies the interchange of digital information between road vehicles with a maximum authorised total mass greater than 3 500 kg. The series also specifies digital information interchange for towed vehicles, including communication between towed vehicles in terms of parameters and requirements of the lower OSI layers (physical and data link layer) of the electrical connection used to connect the electrical and electronic systems. This document specifies the data link and physical layer requirements of the CAN communication bus between towing and towed vehicles. This document has been structured according to the Open Systems Interconnection (OSI) Basic Reference Model, in accordance with ISO/IEC 7498-1 and ISO/IEC 10731, which structures communication systems into seven layers. When mapped on this model, the application protocol and data link layer framework requirements specified/referenced in a ISO 11992 series standard are structured according to Figure 1. Figure 1 illustrates the following communication frameworks: — normal vehicle communication framework; — vehicle diagnostic communication framework; — vehicle-specific use case framework; and — vehicle lower-layers framework. The normal vehicle communication framework is composed of ISO 11992-2 and ISO 11992-3. The vehicle diagnostic communication framework is composed of ISO 14229-1[3], ISO 14229-2[12], ISO 14229-3[13] and ISO 11992-4[3]. The vehicle-specific use case framework is composed of ISO 11

Scope: This document describes the data link layer (DLL) and physical layer (PHY) for the two CAN-based network interfaces specified in the 11992-series. The DLL sub-clauses are composed of: — DLL protocol entity requirements; — DLL device interface requirements; and — DLL network system requirements. Normally, the physical signalling sub-layer is implemented in the CAN protocol controller. The physical medium attachment sub-layer is normally implemented in the CAN transceiver or the System Base Chip (SBC). Optionally, it can comprise also additional protection circuitry. The media-dependent sub-layer comprises the connectors and the cabling. The physical signalling (PS) sub-clauses are composed of: — PS entity requirements; — PS device interface requirements; and — PS network system requirements. The physical medium attachment (PMA) sub-clauses are composed of: — PMA protocol entity requirements; and — PMA device interface requirements. The physical medium dependent (PMD) sub-clauses are composed of: — PMD entity requirements; — PMD device interface requirements; and — PMD network system requirements.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 11992-1-2019 PDF

ISO 11992-1-2019 PDF

$96.50 $193.00