ISO 12004-1-2020 PDF

ISO 12004-1-2020 PDF

Metallic materials-Determination of forming-limit curves for sheet and strip-Part 1: Measurement and application of forming-limit diagrams in the press shop

$48.00 $96.00 -50%
Product Code: ISO 12004-1
Stock In Stock
Edition: 2ND
Published: 10/2020
Number of Pages: 16
File Size: 1 file, 995 Bytes

Available Options

Product Description

Metallic materials — Determination of forming-limit curves for sheet and strip — Part 1: Measurement and application of forming-limit diagrams in the press shop

Introduction: A forming-limit diagram (FLD) is a diagram containing measured major/minor strain points on a formed part. An FLD can distinguish between safe and necked, or failed, points. The transition from safe to failed points is defined by the forming-limit curve (FLC). To determine the forming limit of materials, two different methods are possible. 1) Strain analysis of failed press shop components to determine component and process dependent FLCs In the press shop, strain paths to reach these points are generally not known. Such an FLC depends on the material, the component, and the chosen forming conditions. This method is described in this document and is not intended to determine one unique FLC for each material. 2) Determination of FLCs under well-defined laboratory conditions For evaluating formability, one unique FLC for each material in several strain states can be measured. The determination of FLC must be specific and uses multiple linear strain paths. The ISO 12004-2 is intended for this type of material characterization. © ISO 2020 – All rights reserved

Scope: This document specifies a procedure for developing forming-limit diagrams and forming-limit curves for metal sheets and strips of thicknesses from 0,3 mm to 4 mm.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 12004-1-2020 PDF

ISO 12004-1-2020 PDF

$48.00 $96.00