ISO 12039-2019 PDF

ISO 12039-2019 PDF

Stationary source emissions-Determination of the mass concentration of carbon monoxide, carbon dioxide and oxygen in flue gas-Performance characteristics of automated measuring systems

$60.00 $120.00 -50%
Product Code: ISO 12039
Stock In Stock
Edition: 2ND
Published: 10/2019
Number of Pages: 58
File Size: 1 file, 3 Bytes

Available Options

Product Description

Émissions de sources fixes - Détermination de la concentration de monoxyde de carbone, de dioxyde de carbone et d'oxygène - Caractéristiques de fonctionnement et étalonnage de systèmes automatiques de mesure

Introduction: Carbon monoxide, carbon dioxide, and oxygen are gases found in the exhaust gases of combustion processes. Determination of the concentration of these gases is necessary to demonstrate compliance with local regulations and can assist the operator in the optimization of the combustion process. The determination of O2 and/or CO2 is also necessary to normalize the measured concentration of other gases and dusts to defined conditions. There are a number of ways to measure concentrations of CO, CO2 and O2 in stacks/ducts. © ISO 2019 – All rights reserved

Scope: This document specifies the fundamental structure and the most important performance characteristics of automated measuring systems for carbon monoxide (CO), carbon dioxide (CO2) and oxygen (O2) to be used on stationary source emissions. This document describes methods and equipment for the measurement of concentrations of these gases. The method allows continuous monitoring with permanently installed measuring systems of CO, CO2 and O2 emissions. This international standard describes extractive systems and in situ (non-extractive) systems in connection with analysers that operate using, for example, the following principles: — infrared absorption (CO and CO2); — paramagnetism (O2); — zirconium oxide (O2); — electrochemical cell (O2); — tuneable laser spectroscopy (TLS) (CO, CO2 and O2). Other instrumental methods can be used provided they meet the minimum requirements proposed in this document. Automated measuring systems (AMS) based on the principles above have been used successfully in this application for measuring ranges which are described in Annex G.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 12039-2019 PDF

ISO 12039-2019 PDF

$60.00 $120.00