ISO 12129-1-2024 PDF

ISO 12129-1-2024 PDF

Plain bearings-Tolerances-Part 1: Fits

$48.00 $96.00 -50%
Product Code: ISO 12129-1
Stock In Stock
Edition: 3.
Published: 12/2024
Number of Pages: 16
File Size: 1 file, 2 Bytes

Available Options

Product Description

Plain bearings — Tolerances — Part 1: Fits

Introduction: This document has been established because it is not possible to use the ISO deviations given in ISO 286-1 and ISO 286-2 to develop clearance fits which correspond to the requirements of plain bearing engineering for approximately uniform mean relative bearing clearances for all nominal size ranges. © ISO 2024 – All rights reserved

Scope: This document specifies a system of fits applicable to metallic plain bearings used in general engineering for mean relative bearing clearances, ψm, of 0,56 ‰ up to 3,15 ‰. Other clearance ranges can be used depending upon the requirements in specific applications. This system of fits is not applicable to half-bearings and bushes which, due to their special characteristics, are not measured by diameter but by wall thickness, and which are dimensionally changed on assembly. It is not applicable to profile bore or tilting pad bearings, or to cases where specific tolerances have been established by consideration of the bearing performance at both extremes of clearance. This document is applicable preferably to bearings in rotating machines or transmissions, but it can be used similarly in other ranges of application.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 12129-1-2024 PDF

ISO 12129-1-2024 PDF

$48.00 $96.00