ISO 12219-10-2021 PDF

ISO 12219-10-2021 PDF

Interior air of road vehicles-Part 10: Whole vehicle test chamber-Specification and methods for the determination of volatile organic compounds in cabin interiors-Trucks and buses

$96.50 $193.00 -50%
Product Code: ISO 12219-10
Stock In Stock
Edition: 1ST
Published: 06/2021
Number of Pages: 26
File Size: 1 file, 1 Byte

Available Options

Product Description

Interior air of road vehicles — Part 10: Whole vehicle test chamber — Specification and methods for the determination of volatile organic compounds in cabin interiors — Trucks and buses

Introduction: Volatile organic compounds (VOCs) are widely used in industry and can be emitted by many every-day products and materials. They have attracted much attention in recent years because of their impact on cabin air quality. After homes and workplaces, people spend a lot of time in their vehicles. It is important to determine the material emissions of interior parts and to reduce them to an acceptable level. Therefore, it is important to get comprehensive and reliable information about the types of organic compounds in the interior air of vehicles and also their concentrations. This document outlines a method of measuring the types and levels of VOCs in vehicle cabin air under controlled conditions. It describes requirements for a whole vehicle test chamber and a test protocol. © ISO 2021 – All rights reserved

Scope: This document describes and specifies the whole vehicle test chamber, the vapour sampling assembly and the operating conditions for the determination of volatile organic compounds (VOCs; for more information see Annex E), and carbonyl compounds in vehicle cabin air. There are three measurements performed: one (for VOCs and carbonyl compounds) during the simulation of ambient conditions (ambient mode) at standard conditions of 23 °C with no air exchange; a second only for the measurement of formaldehyde at elevated temperatures (parking mode); and a third for VOCs and carbonyl compounds simulating driving after the vehicle has been parked in the sun starting at elevated temperatures (driving mode). For the simulation of the mean sun irradiation, fixed irradiation in the whole vehicle test chamber is employed. The VOC method is valid for measurement of non-polar and slightly polar VOCs in a concentration range of sub-micrograms per cubic metre up to several milligrams per cubic metre. Using the principles described in this method, some semi-volatile organic compounds (SVOC) can also be analysed. Compatible compounds are those which can be trapped and released from the Tenax TA®1) sorbent tubes described in ISO 16000-6, which includes VOCs ranging in volatility from n-C6 to n-C16. The sampling and analysis procedure for formaldehyde and other carbonyl compounds is performed by collecting air on to cartridges coated with 2,4-dinitrophenylhydrazine (DNPH) and subsequent analysis by high performance liquid chromatography (HPLC) with detection by ultraviolet absorption. Formaldehyde and other carbonyl compounds can be determined in the approximate concentration range 1 μg/m3 to 1 mg/m3. This method applicable to trucks and buses, as defined in ISO 3833:1977 3.1.1 to 3.1.6. This document describes: a) Transport and storage of the test vehicle until the start of the test. b) Conditioning of the surroundings of the test vehicle and the test vehicle itself as well as the whole vehicle test chamber. c) Conditioning of the test vehicle prior to measurements. d) Simulation of ambient air conditions (ambient mode). e) Formaldehyde sampling at elevated temperatures (parking mod

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 12219-10-2021 PDF

ISO 12219-10-2021 PDF

$96.50 $193.00