ISO 12493-2023 PDF

ISO 12493-2023 PDF

Rubber, vulcanized or thermoplastic-Determination of stress in tension under non-isothermal conditions

$71.50 $143.00 -50%
Product Code: ISO 12493
Stock In Stock
Edition: 3.
Published: 01/2023
Number of Pages: 24
File Size: 1 file, 1 Byte

Available Options

Product Description

Rubber, vulcanized or thermoplastic — Determination of stress in tension under non-isothermal conditions

Introduction: Usually, stress relaxation tests (see ISO 6914) are performed at constant temperature conditions because temperature has a strong impact on the relaxation time constants of rubber materials. Depending on the respective relaxation time constant or, more realistic, relaxation time spectrum, those measurements are more or less time consuming and can require testing times of several days, weeks or even months. Accelerated stress relaxation tests can be performed under non-isothermal conditions, if the temperature is increased at a certain constant heating rate, because relaxation processes are thermally activated and therefore occur faster at higher temperatures. Thus, the entire stress relaxation behaviour of the material can be scanned within a short period of time, typically a few hours. This method is designated as the temperature scanning stress relaxation (TSSR) test method and offers the ability to characterize rubber ─ vulcanized or thermoplastic ─ by short-term measurements. TSSR tests cannot replace conventional isothermal stress relaxation measurements, but are considered as a comparative test method, e.g. for the purpose of material pre-selection or in order to determine the state of crosslink density ─ which is an important reason for ageing phenomena ─ of a sample. During non-isothermal testing, the material undergoes not only stress relaxation, but additional phenomena occur which need to be considered by adequate corrections. Most important in this case is an incr

Scope: This document describes two methods for measuring stress in tension under non-isothermal conditions. — Method A: The thermal stress is measured for various pre-strain and temperature conditions as a function of time. — Method B: The change of stress is measured in a test piece at a given strain and under variation of temperature at a given heating rate as a function of temperature. In this way, the determination of the thermal-mechanical behaviour of a rubber can be accelerated, e.g. for the purpose of comparative testing of aging or estimating the upper limit of the operating temperature. The measurement device, which is equipped with a suitable heating chamber, is used to record the stress as a function of time or temperature until the sample breaks or the stress has approached zero or for a certain time.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 12493-2023 PDF

ISO 12493-2023 PDF

$71.50 $143.00