Tissue paper and tissue products — Part 7: Determination of optical properties — Measurement of brightness and colour with D65/10° (outdoor daylight)
Introduction: Brightness and colour measurement can be performed under various illumination and observation conditions. This document deals with D65/10° conditions, which refer to an outdoor daylight. C/2° conditions (indoor daylight) are considered in ISO 12625-15. Although both International Standards deal with brightness and colour, results obtained are usually different and do not correlate. Optical measurement is affected by the geometry of the instruments used and by the texture of the material. The design of the instrument to use according to this document and the routine to adopt for its calibration are specified in ISO 2469 and ISO 11475. The optical properties are related to the visual appearance of the material. Therefore, although optical properties are intrinsic properties of tissue paper, they are not functional properties. Brightness should not be confused with the optical property called CIE whiteness, which is based on reflectance data obtained over the full visible spectral range (VIS) in contrast to the measurement of brightness, which is limited to the blue region of VIS. Due to its importance for some countries, three different test methods for the determination of optical properties were developed: — this document, i.e. ISO 12625-7; — ISO 12625-15; — ISO 12625-16. © ISO 2021 – All rights reserved
Scope: This document specifies testing procedures for the instrumental determination of brightness and colour of tissue paper and tissue products viewed under outdoor daylight conditions. It also gives specific instructions for the preparation of test pieces (single-ply, multi-ply products) and for the optical measurements of products, where special precautions can be necessary. NOTE The properties called ISO brightness and colour with C/2° (indoor daylight) are measured with an instrument adjusted to a much lower UV content than that specified in this document. The measurements of ISO brightness and colour with C/2° (indoor daylight) are described in ISO 12625-15.