ISO 12715-2014 PDF

ISO 12715-2014 PDF

Non-destructive testing - Ultrasonic testing - Reference blocks and test procedures for the characterization of contact probe sound beams

$60.00 $120.00 -50%
Product Code: ISO 12715
Stock In Stock
Edition: 2ND
Published: 06/15/2014
Number of Pages: 32
File Size: 1 file, 868 Bytes

Available Options

Product Description

Non-destructive testing - Ultrasonic testing - Reference blocks and test procedures for the characterization of contact probe sound beams

Introduction: In ultrasonic non-destructive testing, pulse-echo contact tests with a straight-beam probe (also known as a normal-beam probe), an angle-beam probe (also known as an angle probe), or a dual-element probe (also known as a twin-crystal probe) are often used. To reliably detect and characterize a reflector inside a material, knowledge of the sound beam (or the beam profile) generated by the probe in contact with the test object is needed. This International Standard establishes two metal reference blocks to be adopted for various metals such as forged or rolled steel, aluminium, and titanium alloy products. The frequency range of the probes used in this International Standard range from 1 MHz to 15 MHz. Depending on the structure of the materials under evaluation, in general, 1 MHz to 5 MHz is most suitable for steel products and 5 MHz to 15 MHz is most suitable for aluminium and titanium alloys. The two reference blocks introduced are the hemicylindrical-stepped (HS) and the side-drilled-hole (SDH) types, by which the beam profiles generated by straight-beam, focused beam, angle-beam, and dual-element probes can be measured. This International Standard establishes the techniques and procedures to be used for the characterization of probe beam profiles in metals. In pulse-echo ultrasonic tests, the reflected pulse (echo) is used for the detection of discontinuities existing in a material. The discontinuities (such as porosity, voids, or cracks in different sizes and shapes) can

Scope: This International Standard introduces two metal reference blocks, the hemicylindrical-stepped (HS) block and the side-drilled-hole (SDH) block. This International Standard establishes procedures for measuring the sound beam profiles generated by probes in contact with the test object. The probes include straight-beam, angle-beam (refracted compressional and refracted shear wave), focused beam, and dual-element probes. The side dimension of the probe has to be no greater than 25 mm. The methodology of this International Standard provides guidelines for probes to be used for different metals including forged or rolled steel, aluminium, or titanium alloy products. The frequency range of the probes used in this International Standard extends from 1 MHz to 15 MHz, where 1 MHz to 5 MHz is best suited for steels and 5 MHz to 15 MHz is best for fine grain structured alloys such as aluminium products. If this International Standard is to be used for materials other than steels, users should be aware of the fact that the wave velocities in these materials can be different from that of steels and the angle-beam probes are normally designed based on the steel applications. Snell’s law of refraction is described in this International Standard so that correct angles of refraction in other homogeneous and fine-grained materials can be calculated. This International Standard applies to angle-beam probes of all practical angles (0° to 70°) and to focused and dual-element probes. This International Standard does not address the use of surface (Rayleigh) wave probes. This International Standard does not address the estimation of equivalent defect sizes which requires reference blocks with flat-bottomed holes. This International Standard establishes no acceptance criteria, but does establish the technical basis for criteria that can be defined by users.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 12715-2014 PDF

ISO 12715-2014 PDF

$60.00 $120.00