Fibre-reinforced plastics — Determination of the plain-pin bearing strength
Introduction: In preparing this harmonized version to other similar methods, such as prEN 6037 and ASTM D 5961, harmonization with open-hole tests has been achieved where relevant (e.g. specimen and hole size). The method is applicable to all current and future fibre-reinforced plastic composites meeting the requirements of this document. The method described in this document uses the maximum load to define the plain-pin laminate bearing strength. This point is well-defined and has been shown to be at a similar level to the less easily defined, initial failure in the similar “torqued bolt” test(s). In the torqued bolt test, the load can increase after the bearing failure (up to × 2), as the failed material is jammed against the bolt, washers and loading jigs. The property determined applies only to the laminate lay-up tested. The strength properties of “bolted” joints are dependent on the actual conditions involved for the joint being assessed. This includes initial bolt torque (including any load lost in bolt threads), effect of relaxation due to visco-elastic effects, effect of hot/wet conditioning, washer size/over-size, bolt material/rivet details and chamfer depth/plate thickness. It is recommended that additional tests to the plain-pin test be conducted for the actual joint conditions of interest in the applications, as no standardized configuration can represent all these variations. ASTM D 5961 can be used as guidance on bolted joint tests. © ISO 2025 – All rights reserved
Scope: This document specifies a procedure for determining the plain-pin bearing strength of fibre-reinforced plastic composites. The method described in this document is applicable to fibre-reinforced plastic composites with either thermoset or thermoplastic matrices.