ISO 12940-1-2026 PDF

ISO 12940-1-2026 PDF

Petroleum products and lubricants-Determination of roll stability of lubricating grease-Part 1: Dry condition test

$48.00 $96.00 -50%
Product Code: ISO 12940-1
Stock In Stock
Edition: 1.
Published: 02/2026
Number of Pages: 16
File Size: 1 file, 440 KB

Available Options

Product Description

Petroleum products and lubricants — Determination of roll stability of lubricating grease — Part 1: Dry condition test

Introduction: Mechanical stability is one of the most important properties of grease. As a matter of fact, grease must withstand mechanical churning in a bearing or in a gear box. The most commonly used method at the time of publication of this document is to submit grease to mechanical working in a grease worker, whereby the grease is extruded through holes drilled in a work plate for a certain number of strokes. This is the method described in ISO 2137 with the option of 100 000 double strokes. Another method to assess the mechanical stability of grease is specified in ASTM D1263.[1] This method is performed on a wheel hub and tests the leakage tendency of the grease from tapered roller bearings. Instead of extruding the grease through holes or centrifuging it from a non-sealed tapered roller bearing, the method specified in this document (see also ASTM D1831[2] and NF T60-190[3] laminates the grease between a roller weight and a hollow cylinder. This is closer to the stresses that a grease encounters in a bearing. Mechanical stability of a grease depends on the type of thickener, the manufacturing procedure, and its consistency grade. Nevertheless, any grease in a bearing suffers rolling, with the effect of destroying the thickener and its structure. It is not necessary for grease to be in the rolling/sliding contact in a bearing, but the base oil bleeding out from the grease is needed to lubricate the rolling/sliding contact. There should be enough grease in the vicinity of the tribolo

Scope: This document specifies a method for evaluating the change of consistency, as measured by cone penetration, of lubricating grease when worked in the roll stability test apparatus. The method described in this document only applies to grease with cone penetration in the range of 175 × 0,1 mm to 385 × 0,1 mm, as measured using ISO 2137.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 12940-1-2026 PDF

ISO 12940-1-2026 PDF

$48.00 $96.00