Spécification géométrique des produits (GPS) - Indication des états de surface dans la documentation technique de produits
Introduction: This International Standard is a geometrical product specification (GPS) standard and is to be regarded as a general GPS standard (see ISO/TR 14638). It influences link 1 of the chain of standards on roughness, waviness and primary profile. For more detailed information of the relation of this International Standard to other standards and the GPS matrix model, see annex J. This edition of ISO 1302 has been developed for use together with the new editions of the surface texture standards issued in 1996 and 1997, which introduce many radical changes compared with the content of the former surface texture standards issued in the 1980s. The changes are so radical that the drawing indications in some instances have a completely new interpretation. Annex H gives detailed information on these changes. Drawing indications applied on technical drawings according to former editions of this International Standard refer to the rules given in the surface texture standards issued at the time of issue and can only be interpreted according to those surface texture standards. Annex I provides information on former practices. The drawing indications given in this edition are to be used for the unambiguous reference to the new surface texture standards issued in 1996 and 1997. Textual indications in this edition of ISO 1302 are under continuous development within ISO/TC 213 and a separate, detailed standard on this issue is under preparation. Consequently, the textual indications given may chan
Scope: This International Standard specifies the rules for the indication of surface texture in technical product documentation (e.g. drawings, specifications, contracts, reports) by means of graphical symbols and textual indications. It is applicable to the indication of requirements for surfaces by means of a) profile parameters, according to ISO 4287, related to the R-profile (roughness parameters), W-profile (waviness parameters), and P-profile (structural parameters), b) motif parameters, according to ISO 12085, related to the roughness motif, and waviness motif, c) parameters related to the material ratio curve according to ISO 13565-2 and ISO 13565-3. NOTE For the indication of requirements for surface imperfections (pores, scratches etc.), which cannot be specified using surface texture parameters, reference is made to ISO 8785, which covers surface imperfections.
Contents:
- Foreword
- Introduction
- Scope