Surface chemical analysis — Mass spectrometries — Calibration of the mass scale for a time-of-flight secondary ion mass spectrometer
Introduction: Secondary ion mass spectrometry (SIMS) is a powerful technique for the analysis of organic and molecular surfaces. Over the last decade, instrumentation has improved significantly so that modern instruments now have very high repeatability and constancy[2]. A growing need is for the identification of the chemical composition of complex molecules from accurate measurements of the mass of the secondary ions. The relative mass accuracy to do this and to distinguish between molecules that contain different chemical constituents, but are of the same nominal mass (rounded to the nearest integer mass), is thus an important parameter. A relative mass accuracy of better than 10 ppm is required to distinguish between C2H4 (28,031 30 u) and Si (27,976 92 u) in a parent ion with total mass up to 1 000 u, and between CH2 (14,015 65 u) and N (14,003 07 u) in parent ions with total mass up to 300 u. However, in a recent interlaboratory study[3], the average fractional mass accuracy was found to be 150 ppm, which is significantly worse than the accuracy needed for unambiguous identification of ions. A detailed study[4] shows that the key factors degrading the accuracy include the large kinetic energy distribution of secondary ions, non-optimized instrument parameters and extrapolation of the mass scale calibration. This document describes a simple method, using locally sourced material, to optimize the instrumental parameters, as well as a procedure to ensure that accurate calibration of the
Scope: This document specifies a method to optimize the mass calibration accuracy in time-of-flight secondary ion mass spectrometry (SIMS) instruments used for general analytical purposes. This document is only applicable to time-of-flight instruments but is not restricted to any particular instrument design. This document gives guidance for some of the instrumental parameters that can be optimized using this procedure and the types of generic peaks suitable to calibrate the mass scale for optimum mass accuracy.